Search
Now showing items 1-10 of 375
Experimental analysis of fatigue fracture behaviour of Ti-6Al-4V alloys
(Scientific Society for Mechanical Engineering, 2011)
3-D model of solid and gas phase flow in the duct bend behind the mill gas classifier at the fan mill
(Nis University, 2011)
This paper shows the computer simulation of two-phase flow of the mill gases, the solid particles of monodisperse coal dust and the transport fluid. Numeric simulation was performed with the software pack Fluent 6.3.26, ...
3D strain analysis of restored lower jaw with total denture using optical measuring system
(Scientific Society for Mechanical Engineering, 2011)
Elastic-plastic behaviour of welded joints during loading and unloading of pressure vessels
(Elsevier Science Bv, Amsterdam, 2016)
In this paper elastic-plastic behaviour of welded joints during loading and unloading of pressure vessel has been analysed. Two stage pressuring process has been applied in previous experimental investigation and simulated ...
Classical and modernmeasuring methods inexperimental analysis of g -beam structure
(University of Belgrade, 2012)
Predviđanje veka čeličnog žičanog užeta u eksploataciji / Service life prediction of running steel wire ropes
(Institut za ispitivanje materijala, Beograd, 2010)
Vrlo visoka čvrstoća omogućava žičanom užetu da prenese velike zatezne sile i da se kreće po koturima relativno malog prečnika. Žice od čelika vrlo visoke čvrstoće su postojale više od sto godina pre nego što su patentirane, ...
Sensitivity Equation for Transient Three-Dimensional Heat Conduction Problem with Moving Heat Source
(Amer Inst Physics, Melville, 2010)
Sensitivity analysis of transient three-dimensional heat conduction in a plate during process of welding is performed. Crank-Nicolson method with multi-step Douglas-Gunn Alternating Direction Implicit (AD!) method is used ...
The Influence of Power and Velocity of the Heat Source on Temperature Distribution in Plate Welding Problems
(Amer Inst Physics, Melville, 2011)
The main objective of this study is to compare results obtained from some widely used simplified analytical formulas of plate welding problem to results obtained from numerical analysis of this problem based on the solution ...
Fem model for calculation of hydro turbine shaft
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2010)
This paper describes the real problem calculation of stress state of hydro turbine shaft with crack appearance on shaft-flange radii. Finite element method (FEM) is used for calculation of shaft stress state and shaft ...
Experimental - Digital image correlation method and numerical simulation of standard globe valve housing
(Scientific Society for Mechanical Engineering, 2011)