Претраживање
Приказ резултата 1-10 од 26
Stress-strain behaviour of laser welded stainless steel joints
(Croatian Society of Mechanics, 2013)
Modern approach experimental verification of numerical models for tensile tests of welded specimens
(Croatian Society of Mechanics, 2013)
Structural integrity assurance of casing pipes in the oil and gas industry
(WIT Transactions on the Built Environment, 2013)
The exploitation of casing steel pipes used in oil and gas drilling rigs typically involves a corrosive atmosphere, high pressures and elevated temperatures. These conditions can affect the initiation and development of ...
Mars evelope simulation in a high-performance human centrifuge
(International Astronautical Federation, IAF, 2013)
This paper represents an effort to enhance and contribute to the human exploration of Mars, by simulating phases of the Earth-Mars-Earth flight envelope in a high performance human centrifuge. Humans are the most valuable ...
Experimental stress-strain analysis of composite beams
(Croatian Society of Mechanics, 2013)
Lubrication regime analysis on sliding bearing example
(Politecnico di Torino (DIMEAS), 2013)
The influence of corrosion on stress concentration factor at shaft to flange radius
(Springer Netherlands, 2013)
This paper describes the influence of corrosion on stress concentration factor and crack initiation at shaft-flange transition section. The real turbine shaft failure case study is used for research. This case study and ...
Architectural aspect of structural glass roof design
(CRC Press/Balkema, 2013)
The objective of the work is to study some solutions of the design and construction of structural glass roofs. Attractive glazed roofs could be achieved by enlarging the range and size of the glass panels, or by reducing ...
Work optimization for rotary regenerative air preheater based on an increase of heat capacity of the matrix and reduction of leakage in seal clearances
(China International Conference Center for Science and Technology, 2013)
The paper shows a reconstruction of rotary regenerative air preheater in purpose of increase of it's energy efficiency. The increase of matrix heat capacity was examined with minimal modifications to geometry of heat ...
Numerical Analysis of Thermal Conditions for Planning and Further Improvements of Hard Surfacing Experiment
(Amer Inst Physics, Melville, 2013)
An initial goal of this study was to use the results from an existing experiment and to set up as complete as possible the numerical model for the thermal analysis of a hard surfacing process. It was clear from the start ...