Search
Now showing items 1-10 of 21
Color measurement of food products using CIE l*a*b* and RGB color space
(Consulting and Training Center KEY, 2013)
Color of the food is the first parameter of quality evaluated by consumers. What is important is the acceptance of the product even before being consumed. Inspection of food products is done using machine vision, particularly ...
Printing orientation influence on tensile strength of PA12 specimens obtained by SLS
(Springer, 2023)
Selective laser sintering (SLS) is one of the additive manufacturing technologies dedicated to the production of high-quality parts with complex geometries. Here, polyamide 12 (PA12) is a commonly used material, for ...
Development and Improvement of Numerical Models of Welded Joints with Multiple Defects
(Trans Tech Publications, 2023)
This paper presents the development of numerical models which were used to simulate
the behaviour of welded joints containing different combinations of multiple defects under tensile
loads. Four representative combinations ...
Numerical and Experimental Study of Temperature Distribution on Thermal Plant Coal Mill Walls
(Wiley Online LibraryAmerican Institute of Chemical Engineers, 2017)
This article presents results of a numerical and experimental study of the temperature distribution inside and on the walls of the ventilation mill in the Kostolac B power plant, Serbia. This is very important because heat ...
Manufacturing parameter influence on FDM polypropylene tensile properties
(Journal of Mechanical Science and Technology, 2023)
Polypropylene (PP) is a relatively new material in fused deposition modeling (FDM) technology. The main feature of this material is its ability to significantly elongate under applied load, unlike any other thermoplastic ...
Printing parameter optimization of PLA material concerning geometrical accuracy and tensile properties relative to FDM process productivity
(Springer Nature, 2023)
High demand for part customization shifts industries toward AM technologies. Part customization in high-volume manufacturing is developed to its limits, whereas low-volume production using AM is still economically unjustified. ...
Deformation Mechanisms in Ti3Al-Nb Alloy at Elevated Temperatures
(Materiali in Tehnologije (Materials and technology), 2010)
Welding Joint Made of Two Different Austenitic Materials
(Materials Science Forum, 2023)
Using austenitic steel in welding structures requires both destructive and non-destructive testing (NDT) to approve the use of intended welding specification, but also testing of material properties, even if they are ...
The influence of material infill on ABS-X flexural strength
(Springer, 2023)
This paper contains a comparison of the flexural strength results of two different samples. Both samples were made using additive manufacturing, from ABS (acrylonitrile butadiene styrene) material with the inclusion of an ...
Generisanje i upravljanje medicinskim otpadom u Srbiji – pregled
(Tehnika - časopis saveza inženjera i tehničara Srbije, 2016)
U radu su predstavljeni podaci o generisanju, količinama i upravljanju medicinskim otpadom (MO) u
Srbiji. Predstavljeni su načini procene i ukupne godišnje količine generisanja MO po kategorijama.
Zaključeno je da se ...