Претраживање
Приказ резултата 1-10 од 14
Effect of building direction and heat treatment on mechanical properties of Inconel 939 prepared by additive manufacturing
(Springer Nature, 2023)
This study investigated the effect of building direction (BD) and three-step heat treatment on the microstructure and mechanical properties of a nickel-based superalloy Inconel 939 produced by additive manufacturing (AM), ...
The influence of material infill on ABS-X flexural strength
(Springer, 2023)
This paper contains a comparison of the flexural strength results of two different samples. Both samples were made using additive manufacturing, from ABS (acrylonitrile butadiene styrene) material with the inclusion of an ...
Application of Composite Construction and Demolition Debris in Heavy Metals Removal from Industrial Wastewater
(Thermal Science, 2023)
The utilization of construction and demolition debris in industrial wastewater treatment by sorption of Co2+ and Ni2+ ions was investigated. Selected waste composites are cost-effective and locally available, still their ...
Probability distribution on cleavage fracture in function of Jc for reactor ferritic steel in transition temperature region
(Engineering Failure Analysis, 2021)
This paper presents the results and methods used for determining of probability of cleavage fracture toughness of ferritic reactor steel in transition temperature area. The steel tested in this study is steel know as ...
Review: Advantages of Repairing Machine Parts in Order to Restore their Functionality
(Advanced Materials Research, 2022)
This paper covers the literature review of the work by author, who have been involved in
the subject of machine element repairing from the techno-economical point of view. Positive
aspects of repairing, as opposed to ...
Printing orientation influence on tensile strength of PA12 specimens obtained by SLS
(Springer, 2023)
Selective laser sintering (SLS) is one of the additive manufacturing technologies dedicated to the production of high-quality parts with complex geometries. Here, polyamide 12 (PA12) is a commonly used material, for ...
Development and Improvement of Numerical Models of Welded Joints with Multiple Defects
(Trans Tech Publications, 2023)
This paper presents the development of numerical models which were used to simulate
the behaviour of welded joints containing different combinations of multiple defects under tensile
loads. Four representative combinations ...
Manufacturing parameter influence on FDM polypropylene tensile properties
(Journal of Mechanical Science and Technology, 2023)
Polypropylene (PP) is a relatively new material in fused deposition modeling (FDM) technology. The main feature of this material is its ability to significantly elongate under applied load, unlike any other thermoplastic ...
Probability distribution on cleavage fracture in function of Jc for reactor ferritic steel in transition temperature region
(Engineering Failure Analysis, 2021)
This paper presents the results and methods used for determining of probability of cleavage fracture toughness of ferritic reactor steel in transition temperature area. The steel tested in this study is steel know as ...
Printing parameter optimization of PLA material concerning geometrical accuracy and tensile properties relative to FDM process productivity
(Springer Nature, 2023)
High demand for part customization shifts industries toward AM technologies. Part customization in high-volume manufacturing is developed to its limits, whereas low-volume production using AM is still economically unjustified. ...