Претраживање
Приказ резултата 11-20 од 21
Development and Improvement of Numerical Models of Welded Joints with Multiple Defects
(Trans Tech Publications, 2023)
This paper presents the development of numerical models which were used to simulate
the behaviour of welded joints containing different combinations of multiple defects under tensile
loads. Four representative combinations ...
Manufacturing parameter influence on FDM polypropylene tensile properties
(Journal of Mechanical Science and Technology, 2023)
Polypropylene (PP) is a relatively new material in fused deposition modeling (FDM) technology. The main feature of this material is its ability to significantly elongate under applied load, unlike any other thermoplastic ...
Probability distribution on cleavage fracture in function of Jc for reactor ferritic steel in transition temperature region
(Engineering Failure Analysis, 2021)
This paper presents the results and methods used for determining of probability of cleavage fracture toughness of ferritic reactor steel in transition temperature area. The steel tested in this study is steel know as ...
Generisanje i upravljanje medicinskim otpadom u Srbiji – pregled
(Tehnika - časopis saveza inženjera i tehničara Srbije, 2016)
U radu su predstavljeni podaci o generisanju, količinama i upravljanju medicinskim otpadom (MO) u
Srbiji. Predstavljeni su načini procene i ukupne godišnje količine generisanja MO po kategorijama.
Zaključeno je da se ...
The influence of design modifications of cardan shaft driven fork on its stress distribution
(7 th International Quality Conference May 24 th 2013 Center for Quality, Faculty of Engineering, University of Kragujevac, 2013)
This paper presents analysis of effect of geometric parameters variation to stress level and its distribution at driven fork of Cardan joint in power transmitters. In the study, presented in this paper, the maximal stress ...
Printing parameter optimization of PLA material concerning geometrical accuracy and tensile properties relative to FDM process productivity
(Springer Nature, 2023)
High demand for part customization shifts industries toward AM technologies. Part customization in high-volume manufacturing is developed to its limits, whereas low-volume production using AM is still economically unjustified. ...
Heat and mass transfer during contact drying of a sheet of moist material
(Thermal Science, 1999)
Observed are the processes of heat and mass transfer inside the layer (sheet) of wet material placed on flat heating surface of constant, but variable and controllable temperature, and exposed, from above, to the horizontal ...
Welding Joint Made of Two Different Austenitic Materials
(Materials Science Forum, 2023)
Using austenitic steel in welding structures requires both destructive and non-destructive testing (NDT) to approve the use of intended welding specification, but also testing of material properties, even if they are ...
The Possibility of Applying a Universal Testing Machine for Evaluating Food Textures
(Springer, 2024)
The evaluation of food texture is an essential aspect of food quality control, directly influencing consumer acceptance and preference. Various methods have been developed to assess food texture, including sensory evaluation, ...
Dimensional Accuracy of Compressive Specimens Obtained by SLS Technology
(Springer, 2024)
The objective of this study is to examine the accuracy of dimensional measurements for parts produced using Additive Manufacturing (AM) technology. The specific 3D printer employed in this research is Fuse 1 (FormLabs, ...