Претраживање
Приказ резултата 41-50 од 111
Numerical analysis of temperature field during hardfacing process and comparison with experimental results
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
The three-dimensional transient nonlinear thermal analysis of the hard facing process is performed by using the finite element method. The simulations were executed on the open source Salome platform using the open source ...
Water deoxygenation using hollow fiber membrane module with nitrogen as inert gas
(Taylor & Francis Inc, Philadelphia, 2015)
A pilot plant scale fiber membrane system was developed for the removal of dissolved oxygen from water via nitrogen vacuum. Feed water was introduced to the shell side; a nitrogen gas was applied to the lumen side, as an ...
Identification of low cycle fatigue parameters of high strength low-alloy (hsla) steel at room temperature
(Croatian Metallurgical Soc, Zagreb, 2014)
Low cycle fatigue test was performed in ambient atmosphere at room temperature. cycle loading of material, in case of High strength low-alloy steel, entails modifications of its properties and in this paper is therefore ...
Failure investigation and reparation of a crack on the boom of the bucket wheel excavator ERS 1250 Gacko
(Pergamon-Elsevier Science Ltd, Oxford, 2018)
Bucket wheel excavator ERs 1250 has been in operation for over 30 years in the Grae'anica-Gacko mining basin. It is operating in very hard working conditions due to exploiting very solid material, which has adverse effects ...
Effect of aging on mechanical properties of Al-8Si-8Fe-1.4v/SiCp composites
(Faculty of Metallurgy, 2016)
In this study, Al-8Fe-8Si-1.4V/SiCp composites fabricated by squeeze casting process were age-hardened to Study the influence of heat treatment on mechanical properties, such as hardness, bending strength and modulus of ...
Two-dimensional numerical analysis of active flow control by steady blowing along foil suction side by different urans turbulence models
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
The effects of active separation control by steady blowing jets were investigated numerically on three different examples: subsonic flow past Aerospatiale A airfoil at 13 degrees angle-of-attack, transonic flow past NACA ...
The influence of temperature on mechanical properties of the base material (BM) and welded joint (WJ) made of steel S690QL
(Faculty of Metallurgy, 2016)
This paper presents the analysis of the influence of temperature on mechanic properties of the base material and welded joints made of high strength steel. The joints were welded on S690QL high strength steel plates using ...
Measurement of thermal emission during cutting of materials using abrasive water jet
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
This article deals with measurement of the thermal gradient on material during abrasive water jet cutting. The temperature was measured by thermocamera before the technological process started, during the abrasive water ...
Boundary-layer transition detection by thermography and numerical method around bionic train model in wind tunnel test
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2018)
Methods of diagnosing aerodynamic characteristics are constantly developing in order to conduct the precise and energy efficient wind tunnel testing of transport vehicles in the prototype design early stages. This is of a ...
Computational fracture mechanics: An overview from early efforts to recent achievements
(Wiley, Hoboken, 2018)
An overview of the state of the art of computational fracture mechanics is presented, starting from early efforts and going all the way up to recent achievements. Some specific aspects of linear elastic and elastic plastic ...