Претраживање
Приказ резултата 1-10 од 87
Austempering study of unalloyed and alloyed ductile irons
(MANEY PUBLISHING, LEEDS, 2010)
Austempered ductile iron (ADI) proved to be an advanced material as it possesses remarkable combination of high strength, ductility and toughness with good wear resistance and machinability. These properties can be achieved ...
Condition and behaviour diagnostics of drive groups on belt conveyors
(Pergamon-Elsevier Science Ltd, Oxford, 2012)
Belt conveyors are complex systems with drive groups as functionally very important components. Their proper and reliable operational life is directly related to durability of the load-bearing steel structures. Drive units ...
Computation Method in Failure Analysis of Mechanically Fastened Joints at Layered Composites
(Assoc Mechanical Engineers Technicians Slovenia, Ljubljana, 2012)
This paper considers a computation method in failure analysis of layered composites containing pin-loaded holes. The investigation is focused on developing a reliable computation procedure to analyze initial failure load ...
Effect of microstructure on tensile properties of austenite-ferrite welded joint
(Faculty of Metallurgy, 2015)
Complex microstructure of austenite-ferrite welded joint has been investigated, focused on its influence on Focal tensile properties. Tensile properties (yield strength and hardening coefficient) have been evaluated by ...
The standard processing window of alloyed ADI materials
(Kovove Materialy, 2012)
In present paper the effect of austempering conditions and alloying elements on the microstructure, mechanical properties and processing window of Cu and Cu + Ni alloyed austempered ductile irons has been studied. A new ...
Comparative analyses of built environment exposures relevant to health of greenhouse gas emissions reduction strategies in Serbia
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
Paper presents comparative analysis of residential indoor air pollutant concentration change over future specified time horizon, implementing building physical and thermal retrofit measures, thus creating pollution mitigation ...
Numerical analysis of thermal stresses in welded joint made of steels x20 and x22
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
Stress calculation of steam pipeline is presented, focused on the welded joint. Numerical calculation was peiformed using the finite element method to obtain stress distribution in the welded joint made while replacing the ...
Triz method application for improving the special vehicles maintenance
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
TRIZ methodology provides an opportunity for improving the classical engineering approach based on personal knowledge and experience. This paper presents the application of TRIZ methods for improving vehicle maintenance ...
Failure resistance of drilling rig casing pipes with an axial crack
(Pergamon-Elsevier Science Ltd, Oxford, 2015)
Working conditions of casing pipes in drilling rigs can significantly influence the initiation and development of damage in the material, and therefore also the safe service of the entire system. In this work, an integrity ...
Fracture mechanics analysis of damaged turbine rotor discs using finite element method
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
This paper presents evaluation fracture mechanics parameters in low pressure turbine components. Critical locations such as keyway and dovetail area are experiencing stress concentration leading to crack initiation. Stress ...