Претраживање
Приказ резултата 31-40 од 84
Structural integrity and life assessment of rotating equipment
(Pergamon-Elsevier Science Ltd, Oxford, 2020)
Failures of rotating equipment often cause severe consequences, so it is necessary to study their integrity and life as detailed as possible, especially when crack is detected. In the case studied here, hydro power plant ...
Welded joint geometry effect on fatigue crack growth resistance in different metallic materials
(Elsevier Sci Ltd, Oxford, 2021)
Fatigue crack growth through different welded joint regions was investigated, in terms of welded joint geometry and fatigue crack position. In the first phase of investigation, numerical simulation of crack growth in a ...
Thermal-hydraulics of helium cooled First Wall channels and scoping investigations on performance improvement by application of ribs and mixing devices
(Elsevier Science Sa, Lausanne, 2016)
The first wall (FW) of DEMO is a component with high thermal loads. The cooling of the FW has to comply with the material's upper and lower temperature limits and requirements from stress assessment, like low temperature ...
Influence of welded joint microstructures on fatigue behaviour of specimens with a notch in the heat affected zone
(Pergamon-Elsevier Science Ltd, Oxford, 2019)
In this paper, the results of determining the Paris law coefficients, C and m, are presented, based on the experimental data obtained by three-point bending testing of 8 welded joint specimens. The specimens were taken ...
Fracture mechanics and fatigue crack propagation in armor steel welds
(Pergamon-Elsevier Science Ltd, Oxford, 2019)
The welding process of armor steel is a complex process due to possible welding faults appearing in all zones of weld metal joint in the form of cracks and pores, as results of high percentage of carbon in the base metal. ...
Determination of the Actual Stress-Strain Diagram for Undermatching Welded Joint Using DIC and FEM
(MDPI, Basel, 2021)
This paper presents new methodology for determining the actual stress-strain diagram based on analytical equations, in combination with numerical and experimental data. The first step was to use the 3D digital image ...
Human factor risk management procedures applied in the case of open pit mine
(Pergamon-Elsevier Science Ltd, Oxford, 2021)
Risk management aims to provide a controlled work environment to ensure the safe operation of the high-risk systems. It is a dynamic process which work in a continual state of change. The issue of human factor risk and ...
Tie-rods of the bucket wheel excavator slewing superstructure: A study of the eye plate stress state
(Elsevier Sci Ltd, Oxford, 2020)
Tie-rods of the bucket wheel and counterweight booms are vital parts of the bucket wheel excavator slewing superstructure. This paper is dedicated to the problem of identifying the stress state of the critical cross-section ...
Influence of the addition of different radiopacifiers and bioactive nano-hydroxyapatite on physicochemical and biological properties of calcium silicate based endodontic ceramic
(Elsevier Sci Ltd, Oxford, 2021)
The purpose of this study was to investigate the influence of different radiopacifiers on the physicochemical and biological properties of novel calcium silicate based endodontic ceramic enriched with bioactive nanoparticulated ...
Model of seismic design lateral force levels for the existing reinforced concrete European building stock
(Springer, Dordrecht, 2021)
As part of the development of a European Seismic Risk Model 2020 (ESRM20), the spatial and temporal evolution of seismic design across Europe has been studied in order to better classify reinforced concrete buildings (which ...