Претраживање
Приказ резултата 1-10 од 21
Color measurement of food products using CIE l*a*b* and RGB color space
(Consulting and Training Center KEY, 2013)
Color of the food is the first parameter of quality evaluated by consumers. What is important is the acceptance of the product even before being consumed. Inspection of food products is done using machine vision, particularly ...
Effect of building direction and heat treatment on mechanical properties of Inconel 939 prepared by additive manufacturing
(Springer Nature, 2023)
This study investigated the effect of building direction (BD) and three-step heat treatment on the microstructure and mechanical properties of a nickel-based superalloy Inconel 939 produced by additive manufacturing (AM), ...
External Costs on the Environment and Exergo-Economics Methods
(University of Belgrade TECHNICAL FACULTY IN BOR, 2014)
The exergy approach is used in observation of energy transformation processes, it allows estimation of these processes effect on the environment and contributes to the efficiency increasing and evaluation of the environmental ...
Review: Advantages of Repairing Machine Parts in Order to Restore their Functionality
(Advanced Materials Research, 2022)
This paper covers the literature review of the work by author, who have been involved in
the subject of machine element repairing from the techno-economical point of view. Positive
aspects of repairing, as opposed to ...
The influence of design modifications of cardan shaft driven fork on its stress distribution
(7 th International Quality Conference May 24 th 2013 Center for Quality, Faculty of Engineering, University of Kragujevac, 2013)
This paper presents analysis of effect of geometric parameters variation to stress level and its distribution at driven fork of Cardan joint in power transmitters. In the study, presented in this paper, the maximal stress ...
The influence of material infill on ABS-X flexural strength
(Springer, 2023)
This paper contains a comparison of the flexural strength results of two different samples. Both samples were made using additive manufacturing, from ABS (acrylonitrile butadiene styrene) material with the inclusion of an ...
Manufacturing parameter influence on FDM polypropylene tensile properties
(Journal of Mechanical Science and Technology, 2023)
Polypropylene (PP) is a relatively new material in fused deposition modeling (FDM) technology. The main feature of this material is its ability to significantly elongate under applied load, unlike any other thermoplastic ...
Numerical and Experimental Study of Temperature Distribution on Thermal Plant Coal Mill Walls
(Wiley Online LibraryAmerican Institute of Chemical Engineers, 2017)
This article presents results of a numerical and experimental study of the temperature distribution inside and on the walls of the ventilation mill in the Kostolac B power plant, Serbia. This is very important because heat ...
Printing orientation influence on tensile strength of PA12 specimens obtained by SLS
(Springer, 2023)
Selective laser sintering (SLS) is one of the additive manufacturing technologies dedicated to the production of high-quality parts with complex geometries. Here, polyamide 12 (PA12) is a commonly used material, for ...
Welding Joint Made of Two Different Austenitic Materials
(Materials Science Forum, 2023)
Using austenitic steel in welding structures requires both destructive and non-destructive testing (NDT) to approve the use of intended welding specification, but also testing of material properties, even if they are ...