Претраживање
Приказ резултата 1-10 од 20
Failure investigation of the bucket wheel excavator crawler chain link
(Pergamon-Elsevier Science Ltd, Oxford, 2013)
The high mobility of open pit machines in heavy duty conditions provides fertile ground for the occurrence of various failures of the traveling mechanisms' vital parts such as chain links. The goal of the study presented ...
Explicit parametric method for optimal spur gear tooth profile definition
(Trans Tech Publications Ltd, 2013)
The gear tooth profile has an immense effect on the main operating parameters of gear pairs (load capacity, working life, efficiency, vibrations, etc). In current engineering research and practice, there is a strong need ...
The influence of corrosion on stress concentration factor at shaft to flange radius
(Springer Netherlands, 2013)
This paper describes the influence of corrosion on stress concentration factor and crack initiation at shaft-flange transition section. The real turbine shaft failure case study is used for research. This case study and ...
Assessment of the effect of pitting corrosion on fatigue crack initiation in hydro turbine shaft
(Trans Tech Publications Ltd, 2013)
Energy efficiency is a key issue worldwide, and not confined solely to the realm of engineers. Past failures of mechanical power system components must be examined carefully in order to minimise future occurrences and ...
Set-up of a pre-test mock-up experiment in preparation for the HCPB Breeder Unit mock-up experimental campaign
(Elsevier Science Sa, Lausanne, 2013)
The complexity of the experimental set-up for testing a full-scaled Breeder Unit (BU) mock-up for the European Helium Cooled Pebble Bed Test Blanket Module (HCPB-TBM) has motivated to build a pre-test mock-up experiment ...
Developement of Modern Technologies of Copper Alloys Casting
(First Metallurgical & Materials Engineering Congress of South-East Europe (MME SEE 2013), Belgrade, Proceedings and Book of Abstracts, Belgrade, Serbia (23.05-25.05.2013), 2013)
In this paper, results of investigation of casting technology of complex thin-wall copper alloy castings with accent on Lost Foam casting procedure are given. Phases of casting procedure were investigated, along with ...
SUSTAINABLE DEVELOPMENT AND ENVIRONMENTAL QUALITY ENHANCEMENT AS A MOTIVATION FACTOR FOR LAND MANAGEMENT METHOD RESEARCH
(International May Conference on Strategic Management IMKSM2013, 24-26. May 2013, Bor, Serbia, 2013)
Environmental quality increase and global worming prevention are strong motivation
factor for research in the field of land management recovering. Coal, as non renewable
resources and its exploitation causes immense ...
Synthesis of the glass-ceramics based on basalt
(Serbian Ceramic Society Conference “Advanced Ceramic and Application II – New frontiers in multi functional material science and procession”, Book of Abstracts, Belgrade, Serbia (30.09-01.10.2013), 2013)
In this paper, results and investigation of possibility of synthesis of the glass-ceramics based on basalt are presented. Glass-ceramic due to its specific properties (high hardness, abrasion resistance, good chemical ...
The Influence of Modifying Methods on the Quality of Eutectic and Hypereutectic Silumine for Diesel Engine Pistons
(International Journal of Cast Metals Research, 2013)
The results of the investigation of the influence of different modifiers (sodium, phosphorus, antimony and strontium) on the quality of AlSi12CuMgNi and AlSi18CuMgNi alloys, which are used for the production of pistons, ...
Defects in casting caused by hyman error
(3rd International Symposium of Natural Resources Management, Zaječar 30-31 May 2013, Proceedings, 2013)
This paper analysed the influence of various factors on moulding discontinuities and moulding quality. The research established that most causes were rooted in a casting process itself, such as: the method of alloy ...