Pretraživanje
Prikaz rezultata 11-20 od 54
Numerical analysis of local and global buckling of a stiffened beam-column
(Univ Osijek, Tech Fac, Slavonski Brod, 2017)
The linear buckling phenomenon is obviously very important for stability of compressed supports. The determination of buckling resistance is an important characteristic of the design of steel structure. Besides, the presence ...
Optimization of AA5083 Friction Stir Welding Parameters Using Taguchi Method
(Univ Osijek, Tech Fac, Slavonski Brod, 2018)
In this study, Taguchi design was applied to find out the optimized set of friction steel welding parameters in terms of total crack energy, crack initiation energy, and crack propagation energy in weldments. Taguchi ...
Impact of sensor readings of grain mass yield on combine speed
(Strojarski Facultet, 2016)
The paper analyzes the impact of sensor readings of dry grain mass yield of wheat, barley and rapeseed on combine speed during harvesting on three plots. The combine was fitted with site-specific yield monitoring sensors. ...
Compatibility of fracture mechanics parameters and fatigue crack growth parameters in welded joint behaviour evaluation
(Strojarski Facultet, 2013)
Problem of fracture toughness, K-Ic, determination on a crack tip localized in a welded joint is set in principle, since fracture mechanics presumes homogeneous material, not only in a crack tip surrounding but on a distance ...
Potential for improvement of comfort parameters in off-road vehicles of Serbian armed forces
(Strojarski Facultet, 2014)
The paper presents the comparative results of comfort parameter testing inside the cabin of Land Rover Defender off-road vehicles. The measurements were carried out on two vehicle models -110 GS Hard Top and 110 GS Soft ...
Techno-economic analysis of heat exchangers with parallel helical tube coils
(Univ Osijek, Tech Fac, Slavonski Brod, 2014)
The paper deals with the investment and exploitation costs for shell and tube heat exchangers with parallel helical tube coils. The most common correlations for estimating prices of shell and tube heat exchangers found in ...
Mechatronic approach to inventing a novel kind of deformeter
(Univ Osijek, Tech Fac, Slavonski Brod, 2017)
Stress and strain measurements on frames and structures are mainly conducted by the use of strain gauges. A measuring chain applied in such measurements usually consists of strain gauges, amplifiers and data acquisition ...
Numerical-experimental analysis of the foldable containers strength
(Univ Osijek, Tech Fac, Slavonski Brod, 2015)
This paper describes the numerical and the experimental methodology for analysis of plastic packaging strength characteristics that are representative of its strength in the real life. Numerical analysis was conducted by ...
Experimental in-vitro bone cements disintegration with ultrasonic pulsating water jet for revision arthroplasty
(Strojarski Facultet, 2015)
The paper deals with the study of using the selective property of ultrasonic pulsating water jet for the disintegration of the interface created by bone cement between cemented femoral stem and trabecular bone tissue as a ...
Novel Risk Based Assessment of Pressure Vessels Integrity
(Univ Osijek, Tech Fac, Slavonski Brod, 2018)
New methodology for risk based approach to integrity assessment of pressure vessels has been introduced. Namely, the risk matrix has been defined with consequence taken as usual, whereas probability has been separated into ...