Pretraživanje
Prikaz rezultata 611-616 od 616
Metallographic characterization of the heat affected zone in welded joints with multiple defects
(Elsevier B.V., 2023)
This paper is based on extensive research about the influence of multiple different welded joint defects on the integrity of welded structures. In this particular case, the focus was on the heat affected zone and its ...
Numerical simulation of crack growth in welded joints in the presence of multiple defects
(The 27th International Conference on Fracture and Structural Integrity, 2023)
Simulation of crack initiation and propagation which occurred during the tensile
testing of real welded joint specimens made of low-alloyed low-carbon structural
steels is presented in this paper. Welded joints in questions ...
Flexibility of power generation and possibilities for feasible upgrades of coal power plants: a case of the Electric Power Industry of Serbia
(Beograd : Društvo termičara Srbije, 2023)
This paper deals with current status and possibilities for feasible improvement of the flexibility of power generation fleet consisting of aged coal-fired power plants and hydro power plants. The analyses are done by use ...
UTILIZATION OF THE FLUE GAS WASTE HEAT BY THE LOW-PRESSURE ECONOMIZER AT 350 MWE LIGNITE-FIRED POWER PLANT
(Beograd : Društvo termičara Srbije, 2023)
Potential for the waste heat utilization in coal-fired thermal power plants that are in operation for a long period is reflected in an increased temperature of the flue gas at the exit of the regenerative air heater. After ...
Deviations measurements of SLS PA material at compressive specimens
(Innovation Center of Faculty of Mechanical Engineering, Belgrade, Serbia, 2023)
SLS technology is a popular choice in various industries worldwide because of its ability to produce complex geometry components with less effort when compared to conventional methods. The technology involves using materials ...
Investigation of the tensile strength of polymer materials obtained through 3D printing technologies
(Innovation Center of Faculty of Mechanical Engineering, Belgrade, Serbia, 2023)
The subject of this paper is the experimental testing of 3D-printed polymer materials and their tensile strength. The focus was on testing polymer materials that are easily accessible, cost-effective, and do not have ...