Pretraživanje
Prikaz rezultata 11-20 od 67
Sustainable sub-geothermal heat pump heating in Serbia
(Pergamon-Elsevier Science Ltd, Oxford, 2011)
Considering the necessity of improvement of Serbian energy production structure through higher participation of clean and renewable energy sources, the possibility of utilization of low enthalpy geothermal waters have been ...
Failure analysis of the combat jet aircraft rudder shaft
(Pergamon-Elsevier Science Ltd, Oxford, 2011)
This paper analyzes failure causes of the combat jet aircraft rudder shaft (RS) which occurred during the flight mission. A finite element method (FEM), utilized to determine the stress state of the RS subjected to hinge ...
The Influence of Power and Velocity of the Heat Source on Temperature Distribution in Plate Welding Problems
(Amer Inst Physics, Melville, 2011)
The main objective of this study is to compare results obtained from some widely used simplified analytical formulas of plate welding problem to results obtained from numerical analysis of this problem based on the solution ...
Estimation of the number of trays for natural gas triethylene glycol dehydration column
(Elsevier, Amsterdam, 2011)
The paper deals with the tray-to-tray method for determining the required number of trays in columns with intensive entrainment of liquid when the operating line of the "dry working regime" is not straight and with a small ...
Measurement of local deformation fields in dental composites using 3d optical system
(Chemicke Listy, 2011)
Polymerization shrinkage is the single most important local deformation of dental composites that has a substantial effect on the quality of the tooth-restoration interface in clinical conditions. The aim of this study was ...
Surface characterisation of Pb1-XMnXTe alloy by atomic force microscopy and magnetic force mode
(MANEY PUBLISHING, LEEDS, 2011)
In this paper the authors present the results of surface characterisation of a lead telluride alloy conducted by atomic force microscopy and magnetic force microscopy. Relationship between surface morphology, in the range ...
Practical aspects of fail-safe design - calculation of fatigue life of cracked thin-walled structures
(Faculty of Mechanical Engineering in Slavonski Brod, Faculty of Electrical Engineering in Osijek, Faculty of Civil Engineering in Osijek, 2011)
This paper represents fatigue crack growth life prediction in thin-walled structures (plates or shells). There are two analysis results from two different packages of software: NASGRO and FRANC 3D. They are based on Finite ...
Uticaj zaštitnog gasa na žilavost metala šava legure AlMg4.5Mn dobijenog postupkom zavarivanja cirkulacijom / The effect of shielding gas on the toughness of AlMg4.5Mn weld metals made by GMAW
(Univerzitet u Beogradu - Mašinski fakultet, Beograd, 2011)
Analiziran je uticaj zaštitnog gasa, na žilavost metala šava aluminijumske legure AlMg4.5Mn dobijenog MIG/MAG postupkom zavarivanja. Za merenje žilavosti je korišćeno instrumentirano Šarpijevo klatno sa mogućnošću razdvajanja ...
Numerička simulacija faze uranjanja kod zavarivanja trenjem mešanjem / Numerical simulation of the plunge stage in friction stir welding
(Institut za ispitivanje materijala, Beograd, 2011)
U ovom radu je istražena faza uranjanja alata primenom numeričkog modeliranja. Trodimenzionalni model konačnih elemenata (FEM) faze uranjanja je razvijen primenom softvera ABAQUS radi proučavanja termomehaničkih procesa ...
Risk Analysis by Key-coefficient Assessment - Public Lighting Project Example
(Technics Technologies Education Management, 2011)
Project risks analysis model RAKA (Risk. Analysis by Key-factors Assessment) was created primarily for the purposes of industrial product development in small enterprises which operate in an environment of economic and ...