Search
Now showing items 1-10 of 320
Experimental analysis of fatigue fracture behaviour of Ti-6Al-4V alloys
(Scientific Society for Mechanical Engineering, 2011)
3-D model of solid and gas phase flow in the duct bend behind the mill gas classifier at the fan mill
(Nis University, 2011)
This paper shows the computer simulation of two-phase flow of the mill gases, the solid particles of monodisperse coal dust and the transport fluid. Numeric simulation was performed with the software pack Fluent 6.3.26, ...
Analysis of fouling factor in district heating heat exchangers with parallel helical tube coils
(Pergamon-Elsevier Science Ltd, Oxford, 2013)
This paper presents the results of measurements of thermal performance of 8 heat exchangers with parallel helical coils. Measurements were conducted in substations in 2 district heating systems in Serbia: Belgrade and ...
Simultaneous consideration of contingency factors and quality management: An empirical study of Serbian companies
(Academic Journals, Victoria Island, 2011)
The aim of the present paper is to answer whether the QM concept is universal or context-dependent, organic or mechanistic, and theoretical or practical in its essence. The study examines the impact of contingency factors ...
Analysis of local shrinkage patterns of self-adhering and flowable composites using 3D digital image correlation
(Quintessence International, 2011)
Objective: To analyze local shrinkage patterns in terms of surface shrinkage strains and z-axis displacements in a novel self-adhering composite and a conventional flowable composite using three-dimensional digital image ...
Groundwater heat pump selection for high temperature heating retrofit
(Elsevier Science Sa, Lausanne, 2012)
Retrofitting of fossil fuel powered hot water radiator heating systems of the existing buildings by groundwater heat pumps can provide significant energy savings followed by economic and environmental benefits. The paper ...
Austempering study of unalloyed and alloyed ductile irons
(MANEY PUBLISHING, LEEDS, 2010)
Austempered ductile iron (ADI) proved to be an advanced material as it possesses remarkable combination of high strength, ductility and toughness with good wear resistance and machinability. These properties can be achieved ...
Methodology of physical occurrences analogy in researching vehicle lifetime
(Technics Technologies Education Management, 2011)
Lifetime as a critical dimension of the quality of a product is most often studied using the unreliability curve, when there are problems in determining the origin in terms of time limit (Delta t), since monitoring usually ...
3D strain analysis of restored lower jaw with total denture using optical measuring system
(Scientific Society for Mechanical Engineering, 2011)
Experimental and numerical analysis of local mechanical properties of globe valve housing
(Chemicke Listy, 2012)
N. Mitrovic(a), M. Milosevic(b), N. Momcilovic(a), A. Petrovic(a), A. Sedmak(a), T. Maneski(a), and M. Zrilic(c) ((a) University of Belgrade, Faculty of Mechanical Engineering, Belgrade, (b) University of Belgrade, Innovation ...