Претраживање
Приказ резултата 1-10 од 520
3-D model of solid and gas phase flow in the duct bend behind the mill gas classifier at the fan mill
(Nis University, 2011)
This paper shows the computer simulation of two-phase flow of the mill gases, the solid particles of monodisperse coal dust and the transport fluid. Numeric simulation was performed with the software pack Fluent 6.3.26, ...
Virtual consultant in welding - Creation of the content server
(Welding in the World, 2007)
In situations where the end users have no domain experts, a virtual consultant in a form of a software surrounding based on updated internet technologies may often show to them the procedure to follow in a given situation ...
Experimental analysis of fatigue fracture behaviour of Ti-6Al-4V alloys
(Scientific Society for Mechanical Engineering, 2011)
Thermohydraulic experimental design for the European Helium-Cooled-Pebble-Bed Test Blanket Module
(Elsevier Science Sa, Lausanne, 2008)
The peculiarities of the coolant flow in Helium-Cooled-Pebble-Bed Test Blanket Module (TBM) are (i) very intensive heating of the first wall from the plasma side and (ii) very complicated geometry of How domain consisting ...
Design update, thermal and fluid dynamic analyses of the EU-HCPB TBM in vertical arrangement
(Elsevier Science Sa, Lausanne, 2009)
In the frame of the activities of the EU Breeder Blanket Programme and of the Test Blanket Working Group of ITER, the Helium Cooled Pebble Bed Test Blanket Module (HCPB TBM) is developed in Forschungszentrum Karlsruhe (FZK) ...
Micromechanical estimates of the critical values of j-integral for the steel of steam pipelines
(Springer, New York, 2009)
We analyze the level of damage to 14MoV63 steel for steam pipelines under the conditions of crack-growth initiation according to the mechanism of ductile fracture. The state of the material after service for about 100,000 ...
Transition temperature and fracture mode of as-castand austempered ductile iron
(Wiley, Hoboken, 2008)
The ductile to brittle transition temperature is a very important criterion that is used for selection of materials in some applications, especially in low-temperature conditions. For that reason, in this paper transition ...
Variable Coefficients Model for Drying Processes with Conductive Heat Supply
(Taylor & Francis Inc, Philadelphia, 2009)
The proposed model is for heat and mass transfer inside a layer of moist material placed on hot isothermal surface. The relevant thermophysical properties of the material are considered as fully dependent on local temperature ...
Welded penstock, produced of high-strength steel and application of fracture mechanics parameters to structural integrity assessment
(Springer, Dordrecht, 2008)
Application of high-strength steel for welded penstock increased the probability of crack-like defects and in welded joint. Structural integrity assessment procedure is presented and applied to welded penstock produced of ...
Evaluation of damage of steam pipeline steel using local approach to fracture
(American Society of Mechanical Engineers, Pressure Vessels and Piping Division (Publication) PVP, 2008)
In the paper, the level of damage of steam pipeline steel after about 100,000 hours at 540°C (1004 °F) under pressure of 42 bars (609 PSI) is analyzed. Material degradation is estimated using a combined experimental and ...