Претраживање
Приказ резултата 1-10 од 32
Experimental analysis of fatigue fracture behaviour of Ti-6Al-4V alloys
(Scientific Society for Mechanical Engineering, 2011)
3-D model of solid and gas phase flow in the duct bend behind the mill gas classifier at the fan mill
(Nis University, 2011)
This paper shows the computer simulation of two-phase flow of the mill gases, the solid particles of monodisperse coal dust and the transport fluid. Numeric simulation was performed with the software pack Fluent 6.3.26, ...
Simultaneous consideration of contingency factors and quality management: An empirical study of Serbian companies
(Academic Journals, Victoria Island, 2011)
The aim of the present paper is to answer whether the QM concept is universal or context-dependent, organic or mechanistic, and theoretical or practical in its essence. The study examines the impact of contingency factors ...
Analysis of local shrinkage patterns of self-adhering and flowable composites using 3D digital image correlation
(Quintessence International, 2011)
Objective: To analyze local shrinkage patterns in terms of surface shrinkage strains and z-axis displacements in a novel self-adhering composite and a conventional flowable composite using three-dimensional digital image ...
Methodology of physical occurrences analogy in researching vehicle lifetime
(Technics Technologies Education Management, 2011)
Lifetime as a critical dimension of the quality of a product is most often studied using the unreliability curve, when there are problems in determining the origin in terms of time limit (Delta t), since monitoring usually ...
3D strain analysis of restored lower jaw with total denture using optical measuring system
(Scientific Society for Mechanical Engineering, 2011)
Sustainable sub-geothermal heat pump heating in Serbia
(Pergamon-Elsevier Science Ltd, Oxford, 2011)
Considering the necessity of improvement of Serbian energy production structure through higher participation of clean and renewable energy sources, the possibility of utilization of low enthalpy geothermal waters have been ...
Failure analysis of the combat jet aircraft rudder shaft
(Pergamon-Elsevier Science Ltd, Oxford, 2011)
This paper analyzes failure causes of the combat jet aircraft rudder shaft (RS) which occurred during the flight mission. A finite element method (FEM), utilized to determine the stress state of the RS subjected to hinge ...
The Influence of Power and Velocity of the Heat Source on Temperature Distribution in Plate Welding Problems
(Amer Inst Physics, Melville, 2011)
The main objective of this study is to compare results obtained from some widely used simplified analytical formulas of plate welding problem to results obtained from numerical analysis of this problem based on the solution ...
Estimation of the number of trays for natural gas triethylene glycol dehydration column
(Elsevier, Amsterdam, 2011)
The paper deals with the tray-to-tray method for determining the required number of trays in columns with intensive entrainment of liquid when the operating line of the "dry working regime" is not straight and with a small ...