Search
Now showing items 1-7 of 7
Calculation of the Archard's wear coefficient of the polymer-based composite sliding bearings
(Univerzitet u Novom Sadu - Fakultet tehničkih nauka, Novi Sad, 2018)
Prediction and calculation of wear of the mechanical components in contact is one of the most important tasks in modern engineering. Due to time consumptive experiments and quite expensive test rig, it became even more ...
Research correlation vegetation index of corn with speed of movement sensor and elevation of field
(Univerzitet u Novom Sadu - Fakultet tehničkih nauka, Novi Sad, 2018)
This paper presents field scouting of corn in order to determine the content of nitrogen in the green parts of the plants. The aim was to measure the vegetative index using two optical sensors by OptRx AGL Technology. The ...
Efficiency analysis of planetary gears
(Univerzitet u Novom Sadu - Fakultet tehničkih nauka, Novi Sad, 2018)
By kinematic combinations of toothed pairs with external and internal contacts, we can obtain planetary gears with a considerably improved performance than the corresponding ones with fixed axes, as well as planetary gears ...
Typified machine parts series load capacity analysis from aspect of structural strength
(Univerzitet u Novom Sadu - Fakultet tehničkih nauka, Novi Sad, 2018)
Application of typization in the process of designing mechanical sub-assemblies and assemblies is one of the ways to reduce the cost of production. Therefore, nowadays, not only roller bearings, bolts, wedges, etc. are ...
The effect of exploitation conditions on the damage of a roller reducer toothed shaft and its repair
(Univerzitet u Novom Sadu - Fakultet tehničkih nauka, Novi Sad, 2018)
This paper describes repair method of the toothed shaft of roller reducer located in Steelworks Smederevo facility, as well as the effects of exploitation conditions that have led to damage i.e. shaft fracture. After more ...
Comparison of 3D Printed Gear's Geometrical Characteristics
(Univerzitet u Novom Sadu - Fakultet tehničkih nauka, Novi Sad, 2018)
A study of the influence of extruded material type and layer thickness on the surface roughness and the geometry accuracy on a 3D printed gear tooth profile is presented in this paper. A whole set of samples with the same ...
Contact stresses and deformations in thrust ball bearing
(Univerzitet u Novom Sadu - Fakultet tehničkih nauka, Novi Sad, 2018)
The aim of this paper is to determine deformations and stresses in the statically loaded thrust ball bearing subjected to a centric external axial load. In this case, all balls in the bearing are equally engaged in the ...