Претраживање
Приказ резултата 31-40 од 45
OPTIMIZATION OF YIELD OF A FLAT PLATE SOLAR WATER COLLECTOR BY SIMULATION WITH MATLAB
(University of Belgrade, Faculty of Agriculture, Serbia., 2023)
This study consists at the modeling and the application of numerical
methods in order to optimize the performance of a flat-water solar collector under the
meteorological conditions of Mali, particularly in the month of ...
Calculation of the Archard’s wear coefficient of the polymer-based composite sliding bearings
(KOD 2018 – The 10th International Conference on Machine And Industrial Design In Mechanical Engineering, 2018)
A New Approach In Lecture Delivery At The Course On Mechanism Design At The Faculty Of Mechanical Engineering, University Of Belgrade
(SUGIG, 2016)
This paper exposes the new and contemporary approach in lectures delivery at the course on Mechanism Design at the Faculty of Mechanical Engineering, University of Belgrade. Since students already obtained and elaborated ...
Simulacija kinematike troosne paralelne mašine sa translatorno pokretnim aktuatorima duž X ose / Simulation of kinematics of three axes parallel kinematics machine tool with linear actuators along X axis
(Univerzitet u Banja Luci, Mašinski fakultet, 2005)
U radu se razmatra simulacija kinematike jedne troosne paralelne mašine. Poznato je da su oblik i veličina radnog prostora slabost većine mašina sa paralelnom kinematikom (MPK). U radu se razmatra razvijeni paralelni ...
A post‐processor for the five‐axis machine MultiProDesk based on inverse kinematic transformation
(University of Banja Luka, Faculty of Mechanical Engineering, 2023)
This paper shows the development of a post‐processor for a five‐axis table tilting machine. Postprocessing software transforms a machining toolpath in CL file into G‐code, which is necessary for the machining process in ...
Modelling and Simulating the Digital Measuring Twin Based on CMM
(MDPI, Basel, Switzerland, 2023)
In order to perform the inspection planning process on the coordinate measuring machine
(CMM), it is necessary to model the measuring system with workpiece, CMM and fixture. The
metrological analysis of the workpiece is ...
Konfigurisanje EMC2 za programiranje i simulaciju višeosnih mašina alatki u Python virtuelnom grafičkom okruženju / Configuring EMC2 for programming and simulation multi axis machine tools in python virtual environment
(Novi Sad : Faculty of Technical Sciences, 2008)
U radu će biti predstavljen način simulacije višeosnih mašina alatki u open-source softverskom paketu EMC2. Kroz primer vertikalnog strugarskog obradnog centra i šestoosnog robota, biće prikazan način integrisanja funkcija ...
Virtual Simulator for five axis vertical Turrning Center in Python graphical Environment Integrated with Open Architecture Control System
(Faculty of Technical Sciences, Department of Production Engineering, 2009)
This paper proposes how to simulate five axis vertical turning center in open architecture software
environment EMC2 (Enhanced Machine Controller). It was shown how to integrate functions of direct and inverse kinematics, ...
Computational modeling and simulation of walking mechanism
(Faculty of Civil engineering and Architecture in NišSerbian Society for Geometry and Graphics SUGIG, 2014)
This paper explains the basic principles on which the walker
mechanism for the rehabilitation of injured people is functioning. This
paper presents the mechanism geometry, kinematics of its work as
well as the appropriate ...
SIMULATION OF MACHINES FOR MECHANICAL OPERATION OF GRAPES IN WINERY
(Faculty of Civil engineering and Architecture in NišSerbian Society for Geometry and Graphics SUGIG, 2014)
This paper presents the mechanical operations in the processing of grapes in wine-making process. In the software package SolidWorks modeling was performed for certain machines used in wineries and then performed a simulation ...