Претраживање
Приказ резултата 1-10 од 773
Serbian and Libyan Anthropometric Measurements Data in Contemporary Systems’ Design
(AHFE International, 2022)
The aim of this paper is to compare Serbian and Libyan anthropometric measurements, such as foot length, standing height, sitting height, lower leg length, upper leg length, shoulder width, hip breadth, arm length and body ...
Sensitivity Analysis in Dynamic Systems: Exploring Insights
(Trans Tech Publications, 2023)
Structural design optimization for dynamic behavior is crucial for structures reliant on their dynamic characteristics for operational performance and integrity.
THE LATEST STANDARDS OF ROLLING BEARING TESTING
(International scientific and professional conference Politehnika 2023, Belgrade, 15th December 2023, 2023)
The wide use of rolling bearings requires a high level of control. Bearing damage can lead
to serious consequences such as equipment failure, loss of control, human injury, increased
maintenance costs, and issues with ...
The Risk assessment of 3D printing FDM technology
(Second International Symposium on Risk Analysis and Safety of Complex Structures and Components (IRAS 2023), Procedia Structural Integrity, 2023)
Additive manufacturing or 3D printing is used nowadays in a variety of industries including aerospace, automotive, medicine, architecture etc. It is also extensively used for educational purposes. 3D printers are now used ...
Numerical Simulation of Aerodynamic Performance of Wing with Split Winglets
(Belgrade : Military Technical Institute, 2020)
Winglet is an additional surface in a form of vertical or horizontal extension of the wing. The shape of winglet changed during the development period and depending on the type of aircraft on which they were installed. Due ...
Mass minimization of an AFG Timoshenko cantilever beam with a large body placed eccentrically at the beam end
(Beograd : Srpsko društvo za mehaniku, 2021)
Shape optimization of an AFG Timoshenko cantilever beam of a variable cross-sectional
area, with a specified fundamental frequency, is considered. The cantilever beam has a finitedimensional
body placed eccentrically at ...
Optimisation of waste heat recovery system in paper machine dryer section
(IEEE, New York, 2021)
In this paper the optimal surface area of an air-to-air plate heat exchanger is determined. The analysis is based on input data obtained by measurement in real operating conditions in board producing paper machine in ...
Fracture Analysis of Composite Beam Element: Case Study
(Trans Tech Publications, 2023)
This paper presents a fracture analysis of a composite beam element through an in-depth case study.
Dynamic Simulation of Dual Mass Flywheel
(Springer International Publishing Ag, Cham, 2020)
New powertrain design poses new challenges in terms of driveline vibration or ultimately in terms of NVH (Noise Vibration Harshness). Current state of the technology for vibration damping in car powertrains is the so-called ...
Determination of Dynamic Properties of Rubber-Metal Motor Mount of Electric Powertrain
(Springer International Publishing Ag, Cham, 2020)
Increasing the volume of the production of vehicles with electric or hybrid powertrain also leads to specific activities for research and development in this segment. One of the current areas that present the paper deals ...