Претраживање
Приказ резултата 21-30 од 143
Error Estimates for Certain Quadrature Formulae
(FAATNA 2020>22 conference, Book of abstracts, 2022)
Modeling, simulation and control of propeller driven seesaw system with asymmetric geometry using PID controller
(University of Belgrade, Faculty of Mechanical Engineering, 2022)
Various algorithms are used to control modern unmanned aerial systems. However, thanks
to the simplicity of application, the most commonly used control algorithm for aircraft but also
for other dynamic systems in various ...
Innovations in Wastewater Treatment
(2023 Trans Tech Publications Ltd, Switzerland, editors: Mihály Csüllög and Dr. Tamas Mankovits, 2023)
For efficient design and reliable operation of the system, it is necessary to collect as much data as possible on the flow and composition of the wastewater in order to ensure compliance with all regulatory requirements.
Nonlinear Dynamics as a Tool in Selection of Working Conditions for Radial Ball Bearing
(Springer, 2020)
This paper contains elements of a comprehensive research devoted to the dynamic behavior of radial ball bearings in real working conditions. The general motivation for this topic comes from the requirements for high ...
Innovations in Water Treatment
(Trans Tech Publications, 2023)
Filtration and sorption are vital techniques in water purification,
effectively eliminating impurities and microorganisms from the water.
The effects of wind speed and turbulence model on wave formation in open systems
(International Association for Hydro-Environment Engineering and Research (IAHR), 2021)
Open systems, that include both water and air fractions, and whose behavior is highly dominated by the interaction between these two phases are particularly important and interesting for many industrial applications (e.g. ...
Overview of numerical methods for solving optimal control problem in guidance algorithms
(Univerzitet u Beogradu, Mašinski fakultet, 2022)
Numerical techniques for solving optimal control problems fall into two general classes: indirect methods and direct methods. In an indirect method, we rely on the Pontryagin's maximum principle and other necessary conditions ...
Numerical analysis of screw joint turn table and chassis of low-floor articulated bus IK218N
(Belgrade : Innovation Center of Faculty of Mechanical Engineering, 2020)
Rapid growth and development of modern technologies led to increased application of innovative solutions in conceptual design and modelling in all fields of engineering. In order to answer to the increased requirements for ...
Water cavitation tunnel characterisation by LDV
(International Association for Hydro-Environment Engineering and Research (IAHR), 2021)
Water cavitation tunnel T-33, which exists in the Experimental Aerodynamics Laboratory of the Military Technical Institute, in Belgrade, since 1952 is presented in this paper. It is a continuous close-loop water tunnel. ...
Design of small-scale composite vertical-axis wind turbine blade
(Belgrade : Innovation Center of Faculty of Mechanical Engineering, 2021)
Although less efficient than their horizontal-axis counterparts, vertical-axis wind turbines (VAWTs) present an interesting research topic as well as a renewable energy converter with lots of potential for application in ...