Search
Now showing items 1-8 of 8
Influence of mechanical activation on the structure of ultrafine BaTiO3 powders
(Elsevier Science Sa, Lausanne, 2009)
The influence of mechanical activation in a planetary ball mill on the change of the structure of BaTiO3 powders has been investigated. The particle size distribution of the nonactivated and activated samples was measured ...
Structural, mechanical and tribological properties of A356 aluminium alloy reinforced with Al2O3, SiC and SiC plus graphite particles
(Elsevier Science Sa, Lausanne, 2010)
Particulate composites with A356 aluminium alloy as a matrix were produced by compocasting process using ceramic particles (Al2O3, SiC) and graphite particles. The matrix alloy and the composites were thermally processed ...
Continuous control as alternative route for wear monitoring by measuring penetration depth during linear reciprocating sliding of Ti6Al4V alloy
(Elsevier Science Sa, Lausanne, 2011)
Continuous wear monitoring during linear reciprocating sliding was investigated. Tribological tests with Ti6Al4V alloy against alumina, at nanotribometer, on microscale, were realised in dry conditions over a range of loads ...
Structural investigation of mechanically activated ZnO powder
(Elsevier Science Sa, Lausanne, 2015)
Commercially available ZnO powder was mechanically activated in a planetary ball mill. In order to investigate the specific surface area, pore volume and microstructure of non-activated and mechanically activated ZnO powders ...
The influence of mechanical activation on structural evolution of nanocrystalline SrTiO3 powders
(Elsevier Science Sa, Lausanne, 2017)
Structural changes caused by mechanical activation of SrTiO3 powders were investigated using a variety of methods. Average crystallite size continuously decreased with increased activation time to around 20 nm after 120 ...
Structural investigation of mechanically activated ZnO powder
(Elsevier Science Sa, Lausanne, 2015)
Commercially available ZnO powder was mechanically activated in a planetary ball mill. In order to investigate the specific surface area, pore volume and microstructure of non-activated and mechanically activated ZnO powders ...
Mixed Mg-Co spinel ferrites: Structure, morphology, magnetic and photocatalytic properties
(Elsevier Science Sa, Lausanne, 2021)
CoxMg1-xFe2O4 (where x was 0.0, 0.1, 0.3, 0.5, 0.7, 0.9 and 1) spinel ferrites were synthesized by the sol-gel combustion method using citric acid as fuel, following the rules of propellant chemistry. Amorphous powders ...
The impedance analysis of sintered MgTiO3 ceramics
(Elsevier Science Sa, Lausanne, 2017)
In the present study the effect of preparation conditions on microstructure and electrical properties of MgTiO3 ceramics was investigated. Mixture of MgO and TiO2 powders was subjected to mechanical activation for different ...