Претраживање
Приказ резултата 1001-1010 од 1045
LDV Investigation of the Self Induced Pre-Swirl and Flow Visualization at the Centrifugal Pump Inlet and Outlet
(39th IAHR World Congress, Proceedings, Ed.: Miguel Ortega-Sánchez, No. 06-08-039-1817, June 19-24th, Granada, Spain, 2022)
Turbulent swirling flow occupies attention of numerous researchers worldwide. In this paper are presented experimental results of the research of the self induced pre-swirl by the centrifugal impeller. Circumferential ...
Finite Time Partial Stability of Fractional Order Time Delay Systems
(China, Nanjing: Hohai University, 2012)
This paper proposes sufficient conditions for finite time stability for the (non)homogeneous
fractional order systems with time delay. Specially, the problem of finite time stability with respect to
some of the variables ...
Experimental Investigations of the Flow Uniformity and Jet Development on the Free Jet Calibration Wind Tunnel
(Serbian Society of Mechanics, 2019)
Results of experimental investigations of the flow uniformity and axisymmetric jet development on the free jet wind calibration tunnel are presented in this paper. At the outlet of calibration tunnel a profiled Witoshinsky ...
Axiomatic Design Theory Applied for Development of Empirical Control Strategy for Learning Robot
(European Education and Training - The TEMPUS Programme, 2008)
The presented research work refers to the development of a completely new approach in the design of manufacturing systems and processes for machining parts, based on the application of artificial intelligence techniques, ...
Development of Continuously Variable Intake Manifold for Formula Student Racing Engine
(Faculty of Engineering, University of Kragujevac, 2014)
After several years of research and development of Formula Student’s air mass flow restricted racing engine at the Internal Combustion Engines Department of the Faculty of Mechanical Engineering, University of Belgrade, ...
Impact Of Industry 4.0 On Agricultural Industry
(SCIENTIFIC-TECHNICAL UNION of MECHANICAL ENGINEERING “INDUSTRY 4.0", 2020)
Industry 4.0 represents the newest generation of industry development. Every day the various demands in industry are getting more and more demanding. The demand for shorter production and delivery time, more efficient and ...
Eigensensitivity andstructural optimization with accent on the repeated frequencies
(Proceedings of the 6th International Congress of Serbian Society of Mechanics, 2017)
Sensitivity analysis is the study of changes in system response with respect to design parameters.
It is being used in a variety of engineering disciplines ranging from automatic control theory to
the analysis of large-scale ...
DEMONSTRATIONAL PUMP SYSTEM / DEMONSTRACIONI PUMPNI SISTEM
(Beograd : Društvo termičara Srbije, 2019)
In this paper is presented the educatioonal pump installation where students could
demonstrate centrifugal pump testing after the international standard ISO 9906 and volumetric
flow meter calibration. Fluid flow phenomenon, ...
Optimization of the bucket wheel boom length using structural reliability approach
(Proceedings of the XXIV International Conference MHCL’22, 2022)
In this paper, structural reliability is applied to compare the original
bucket wheel boom (BWB) of excavator SchRs 740 and the series of boom
structures obtained by lengthening the original boom from 0 to 10 m.
Stress ...
Diagnosis the cause of the crack on the bucket wheel boom on the excavator ERs 1250 Gacko
(The 14th International Conference New Trends in Fatigue and Fracture NT2F14 „Fatigue and fracture at all scales“, 2014)
Bucket wheel excavator ERs 1250 in Gacko has worked
for over 30 years. Excavator was working in very difficult
conditions because it was exploited very solid material
which negatively affected the dynamic behavior of ...