Search
Now showing items 11-20 of 78
A PIC32 based activevibration control ofsmart composite beams
(University of Belgrade, 2012)
Assessment of aircraft wing frequency characteristics
(University of Belgrade, 2012)
Numerical simulation of fatigue crack growth in friction stir welded T joint made of Al 2024 T351 alloy
(Elsevier Science Bv, Amsterdam, 2016)
The Extended Finite Element Method (xFEM) has been applied to simulate fatigue crack growth in an AA2024-T351 T welded joint, 5 mm thick, made by friction stir welding. The ABAQUS and Morfeo software has been used. Tensile ...
Determining of elasticity modulus of fiberglas reinforced plastic grating using finite element method
(VDI Verein Deutscher Ingenieure, 2014)
Work optimization for rotary regenerative air preheater based on an increase of heat capacity of the matrix and reduction of leakage in seal clearances
(China International Conference Center for Science and Technology, 2013)
The paper shows a reconstruction of rotary regenerative air preheater in purpose of increase of it's energy efficiency. The increase of matrix heat capacity was examined with minimal modifications to geometry of heat ...
Design and testing characteristics of thin stainless steel diaphragms
(Elsevier Science Bv, Amsterdam, 2018)
Metal membranes are defined as thin steel circular plates. The metal membranes are widely used in the measurement technique and they are constantly loaded over the entire surface. In case that a membrane is loaded with ...
Development of numerical-experimental model of connecting lugs and application on the lugs calculation of container terminals
(Elsevier Science Bv, Amsterdam, 2018)
The present paper describes numerical and experimental methodology and development of the model for stress and deformation state analysis of the connecting lug of container terminals. Numerical analysis was conducted by ...
Experimental determination of brittle fracturing appearance during static indentation of materials based on stone
(Springer Heidelberg, 2017)
During micro cutting process, the presence of both ductile and brittle mode is observed. The appearance of one or the other, or the value of critical penetration depth, when transition is happening, depends on the material ...
Effects of welding technology on the occurrence of fracture in welded joints
(Elsevier Science Bv, Amsterdam, 2018)
Welded joints represent locations where failure is most likely to occur in welded structures. Welded joint failure depends on their vulnerability to crack initiation and growth. These factors are significantly influenced ...
Oxidation behavior during prolonged service of boiler tubes made of 2.25Cr1Mo and 12Cr1Mo0.3V heat resistance steels
(Elsevier Science Bv, Amsterdam, 2016)
During service of thermal power plant (TPP) units, different components are exposed to high temperature due to technological cycle of TPP unit. Service lifetimes of these components, especially boiler heating surfaces, may ...