Претраживање
Приказ резултата 1-10 од 79
Thermal-hydraulic analysis of a steam boiler with rifled evaporating tubes
(Pergamon-Elsevier Science Ltd, Oxford, 2007)
Rifled evaporating tubes are applied in the steam boilers with the aim to increase the steam-water mixture turbulization and to prevent the burnout of tubes walls. The rifled evaporating tubes and the working fluid forced ...
Modelling of ductile fracture initiation in strength mismatched welded joint
(Pergamon-Elsevier Science Ltd, Oxford, 2008)
In this paper, the effect of strength mismatch and width of the welded joints oil the stress-strain distribution in the crack tip region has been discussed. The single-edge notched bend (SENB) specimens (precrack length ...
A computer code for the prediction of mill gases and hot air distribution between burners' sections at the utility boiler
(Pergamon-Elsevier Science Ltd, Oxford, 2008)
One of the main tasks during the design or simulation and analyses of the utility steam boiler operation is the prediction of a distribution of mill gases and hot air flow rates between burners' sections. These are the ...
Failure analysis of the combat jet aircraft rudder shaft
(Pergamon-Elsevier Science Ltd, Oxford, 2011)
This paper analyzes failure causes of the combat jet aircraft rudder shaft (RS) which occurred during the flight mission. A finite element method (FEM), utilized to determine the stress state of the RS subjected to hinge ...
Estimation of the number of trays for natural gas triethylene glycol dehydration column
(Elsevier, Amsterdam, 2011)
The paper deals with the tray-to-tray method for determining the required number of trays in columns with intensive entrainment of liquid when the operating line of the "dry working regime" is not straight and with a small ...
Bucket chain excavator: Failure analysis and redesign of the counterweight boom supporting truss columns
(Pergamon-Elsevier Science Ltd, Oxford, 2013)
The supporting truss of the counterweight boom is a vital part of the bucket chain excavator's (BCE) superstructure. The occurrence and propagation of cracks in the supporting truss columns' heads may lead to BCE collapse. ...
Analysis of welded tensile plates with a surface notch in the weld metal and heat affected zone
(Pergamon-Elsevier Science Ltd, Oxford, 2010)
The behavior of the plates with a surface notch under tensile external loading is experimentally and numerically analyzed. The specimens were made of micro-alloyed steel NIO-MOL 490 K. welded by MAC (CO2) welding method. ...
Load-bearing steel structure diagnostics on bucket wheel excavator, for the purpose of failure prevention
(Pergamon-Elsevier Science Ltd, Oxford, 2011)
The appearance of cracks on load-bearing steel structure of compact, hydraulic bucket wheel excavator was a perennial problem. Unfavourable stress concentration, inadequate geometry and structure of materials, inadequate ...
Analysis of the unstable fracture behaviour of a high strength low alloy steel weldment
(Pergamon-Elsevier Science Ltd, Oxford, 2004)
Local brittle zones (LBZ) cause the unstable fracture behaviour of weld metals. This threatens the safe service of welded structures and makes structural assessment procedures difficult. Therefore, the unstable fracture ...
Formation of fouling layers on a heat exchanger element exposed to warm, humid and solid loaded air streams
(Elsevier Science Inc, New York, 2002)
In consideration of the very high energy consumption of drying processes it is astonishing and disadvantageous that the majority of industrial dryers are offered and operated without energy recovery. The avoidance of fouling ...