Претраживање
Приказ резултата 1-10 од 18
Color measurement of food products using CIE l*a*b* and RGB color space
(Consulting and Training Center KEY, 2013)
Color of the food is the first parameter of quality evaluated by consumers. What is important is the acceptance of the product even before being consumed. Inspection of food products is done using machine vision, particularly ...
Effect of building direction and heat treatment on mechanical properties of Inconel 939 prepared by additive manufacturing
(Springer Nature, 2023)
This study investigated the effect of building direction (BD) and three-step heat treatment on the microstructure and mechanical properties of a nickel-based superalloy Inconel 939 produced by additive manufacturing (AM), ...
Probability distribution on cleavage fracture in function of Jc for reactor ferritic steel in transition temperature region
(Engineering Failure Analysis, 2021)
This paper presents the results and methods used for determining of probability of cleavage fracture toughness of ferritic reactor steel in transition temperature area. The steel tested in this study is steel know as ...
Deformation Mechanisms in Ti3Al-Nb Alloy at Elevated Temperatures
(Materiali in Tehnologije (Materials and technology), 2010)
Development and Improvement of Numerical Models of Welded Joints with Multiple Defects
(Trans Tech Publications, 2023)
This paper presents the development of numerical models which were used to simulate
the behaviour of welded joints containing different combinations of multiple defects under tensile
loads. Four representative combinations ...
Welding Joint Made of Two Different Austenitic Materials
(Materials Science Forum, 2023)
Using austenitic steel in welding structures requires both destructive and non-destructive testing (NDT) to approve the use of intended welding specification, but also testing of material properties, even if they are ...
Printing orientation influence on tensile strength of PA12 specimens obtained by SLS
(Springer, 2023)
Selective laser sintering (SLS) is one of the additive manufacturing technologies dedicated to the production of high-quality parts with complex geometries. Here, polyamide 12 (PA12) is a commonly used material, for ...
Review: Advantages of Repairing Machine Parts in Order to Restore their Functionality
(Advanced Materials Research, 2022)
This paper covers the literature review of the work by author, who have been involved in
the subject of machine element repairing from the techno-economical point of view. Positive
aspects of repairing, as opposed to ...
Manufacturing parameter influence on FDM polypropylene tensile properties
(Journal of Mechanical Science and Technology, 2023)
Polypropylene (PP) is a relatively new material in fused deposition modeling (FDM) technology. The main feature of this material is its ability to significantly elongate under applied load, unlike any other thermoplastic ...
The influence of design modifications of cardan shaft driven fork on its stress distribution
(7 th International Quality Conference May 24 th 2013 Center for Quality, Faculty of Engineering, University of Kragujevac, 2013)
This paper presents analysis of effect of geometric parameters variation to stress level and its distribution at driven fork of Cardan joint in power transmitters. In the study, presented in this paper, the maximal stress ...