Pretraživanje
Prikaz rezultata 51-60 od 206
Optical Aspect of Deformation Analysis in the Bone-Denture Complex
(Collegium Antropologicum, 2012)
The aim of this study was to register and measure any deformation of mandible models under load. The method for full field measurement of strain is done by using the ARAMIS three-dimensional image correlation system. The ...
Risk management and multicriteria optimization of production program
(Metalurgia International, 2012)
The paper presents the integration of risk mamagement methodology and multicriterial optimization of production program. The aim of the research is development an integrated risk management model and multicriterial ...
Improving structure dynamic behaviour using a reanalysis procedures technique
(Univ Osijek, Tech Fac, Slavonski Brod, 2013)
The present paper deals with the problem of improving dynamic characteristics for a sub-structure of bucket wheel excavator. The procedure is concerned with the analysis of the distribution of potential and kinetic energy ...
determining the reliability function of the thermal power system in power plant "nikola tesla, block b1"
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2015)
Representation of probabilistic technique for evaluation of thermal power system reliability is the main subject of this paper. The system of thermal power plant under study consists of three subsystems and the reliability ...
Influence of application of Hottel's zonal model and six-flux model of thermal radiation on numerical simulations results of pulverized coal fired furnace
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2012)
Difference of results of numerical simulation of pulverized coal fired furnace when mathematical models contain various radiation models has been described in the paper. Two sets of numerical simulations of pulverized coal ...
Measurement of local tensile properties of welded joint using digital image correlation method
(Chemicke Listy, 2012)
M. Milosevic(a), N. Mitrovic(b), R. Jovicic(a), A. Sedmak(b), T. Maneski(b), A. Petrovic(b), and T. Aburuga(b) ((a)Innovation Center of Faculty of Mechanical Engineering, b Faculty of Mechanical Engineering, University of ...
Redesigning components of power transmission according to numerical model and vibration diagnostics
(Journal Vibroengineering, Kaunas, 2013)
This article presents derived methodological procedure of redesigning shaft, gear box, bucket wheel of bucket wheel excavator. Method of finite elements has been used for defining numerical model of shaft. As validation ...
Application and design of an economizer for waste heat recoveryin a co-generation plant
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2016)
Energy increase cost has required its more effective use. However, many industrial heating processes generate waste energy. Use of waste-heat recovery systems decreases energy consumption. This paper presents case study ...
The fundamental role of fluid dynamic analyses in the design of the solid EU Test Blanket Module
(Elsevier Science Sa, Lausanne, 2012)
In the frame of the activities of the European Test Blanket Module Consortium of Associates, the Helium Cooled Pebble Bed Test Blanket Module (HCPB TBM), the so-called solid TBM, is developed in Karlsruhe Institute of ...
Effects of operation temperature on thermal expansion and main parameters of radial ball bearings
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2015)
The research of influence of operation temperature on the thermal expansion and main parameters of radial ball bearings is presented in this paper. The main bearing parameters are identified in accordance with the increasing ...