Search
Now showing items 31-40 of 321
Prediction of crack initiation in spur gear contact zone
(Univ Novi Sad, Fac Tech Sci, Adeko, Novi Sad, 2012)
The objective of this paper is to give a new viewpoint in contact fatigue prediction in the case of high-cycle fatigue. The presented research is based on up-to-date methods and multidisciplinary approach, and enables ...
Using Open Standards Based Building Information Modelling to Simulate Actual Design and Construction Processes
(Education and research in Computer Aided Architectural Design in Europe, 2011)
The paper describes pilot project conducted to achieve first understanding of the IFC standard and BIM process in Serbia. During the project a research team have developed information model of the actual building using IFC ...
Influence of crack length on ductile fracture initiation in welded joints with one and two weld metals
(Trans Tech Publications Ltd, Durnten-Zurich, 2011)
Among various micromechanical models for ductile fracture analysis using local approach, those based on the Gurson plastic flow criterion have been intensively developed in the past three decades. However, their application ...
HETRA experiment for investigation of heat removal from the first wall of helium-cooled-pebble-bed test blanket module
(Elsevier Science Sa, Lausanne, 2011)
This paper presents an experimental test section which has been developed at the Institute for Neutron Physics and Reactor Technique in Karlsruhe Institute of Technology for investigations of heat removal from the first ...
Weld metal tensile strength determined by testing flat micro tensile and round tensile specimens
(Scientific Society for Mechanical Engineering, 2011)
Experimental investigation of temperature and strain-rate behaviour of Ti3Al-Nb alloy
(Scientific Society for Mechanical Engineering, 2011)
API J55 Steel Casing Pipe with an Initial Surface Crack under Internal Pressure - Determination of Fracture Parameters
(Trans Tech Publications Ltd, Durnten-Zurich, 2012)
Seam casing pipe used in an oil drilling rig, manufactured by high frequency (HF) contact welding of API J55 steel, is tested. The influence of an initial defect (machined surface crack) is analysed, by performing pressure ...
Energetic and environmental sustainability of sub-geothermal heat pump heating in Serbia
(Journal of Environmental Protection and Ecology, 2012)
Feasibility of low enthalpy geothermal waters incorporation in Serbian energy source structure has been investigated. Energy potential of ground waters of modest temperature levels is usually neglected since they can not ...
Experimental analysis of artificial hip implant made of titanium alloy
(University of Belgrade, 2012)
Characterisation of High-Carbon Steel Surface Welded Layer
(Assoc Mechanical Engineers Technicians Slovenia, Ljubljana, 2010)
In this paper microstructural and mechanical properties of high-carbon steel surface welded layer obtained with self-shielded flux cored wire are presented in standard rails and crossings. The testing results of tensile ...