Pretraživanje
Prikaz rezultata 21-30 od 124
Diagnostics of bucket wheel excavator discharge boom dynamic performance and its reconstruction
(Polish Academy of Sciences Branch Lublin, 2014)
The paper focuses on an investigation into the possible causes of the bad dynamic performance of bucket wheel excavator C7OOS (BWE) discharge boom in the Kolubara opencast mine, Serbia. A discharge boom load carrying ...
Structural life assessment of oil rig pipes made of api j55 steel by high frequency welding
(Faculty of Mechanical Engineering in Slavonski Brod, Faculty of Electrical Engineering in Osijek, Faculty of Civil Engineering in Osijek, 2013)
Structural life of welded pipes made of API J55 steel by high-frequency (HF) welding has been evaluated. Experimental tests of base metal mechanical properties, including fatigue properties, were conducted on pipes after ...
Heat input effect of friction stir welding on aluminum alloy aa 6061-t6 welded joint
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2016)
The paper deals with the heat input and maximum temperature developed during friction stir welding with different parameters. Aluminum alloy (AA 6061-T6) has been used for experimental and numerical analysis. Experimental ...
Improving structure dynamic behaviour using a reanalysis procedures technique
(Univ Osijek, Tech Fac, Slavonski Brod, 2013)
The present paper deals with the problem of improving dynamic characteristics for a sub-structure of bucket wheel excavator. The procedure is concerned with the analysis of the distribution of potential and kinetic energy ...
determining the reliability function of the thermal power system in power plant "nikola tesla, block b1"
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2015)
Representation of probabilistic technique for evaluation of thermal power system reliability is the main subject of this paper. The system of thermal power plant under study consists of three subsystems and the reliability ...
Influence of application of Hottel's zonal model and six-flux model of thermal radiation on numerical simulations results of pulverized coal fired furnace
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2012)
Difference of results of numerical simulation of pulverized coal fired furnace when mathematical models contain various radiation models has been described in the paper. Two sets of numerical simulations of pulverized coal ...
Redesigning components of power transmission according to numerical model and vibration diagnostics
(Journal Vibroengineering, Kaunas, 2013)
This article presents derived methodological procedure of redesigning shaft, gear box, bucket wheel of bucket wheel excavator. Method of finite elements has been used for defining numerical model of shaft. As validation ...
Application and design of an economizer for waste heat recoveryin a co-generation plant
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2016)
Energy increase cost has required its more effective use. However, many industrial heating processes generate waste energy. Use of waste-heat recovery systems decreases energy consumption. This paper presents case study ...
Effects of operation temperature on thermal expansion and main parameters of radial ball bearings
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2015)
The research of influence of operation temperature on the thermal expansion and main parameters of radial ball bearings is presented in this paper. The main bearing parameters are identified in accordance with the increasing ...
Study on impact properties of creep-resistant steel thermally simulated heat affected zone
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2012)
The steam pipe line and steam line material, along with its welded joints, subject to damage that accumulates during operation in coal power plants. As a result of thermal fatigue, dilatation of steam pipe line at an ...