Претраживање
Приказ резултата 21-30 од 116
True Stress-strain Curves for HSLA Steel Weldment - Iteration Procedure Based on DIC and FEM
(Elsevier, Amsterdam, 2020)
True stress-strain curves of HSLA steel welded joint regions were estimated by using numerical simulation of strains measured by DIC and special iteration procedure to match the results. Strains were measured at certain ...
Development of numerical-experimental model of connecting lugs and application on the lugs calculation of container terminals
(Elsevier Science Bv, Amsterdam, 2018)
The present paper describes numerical and experimental methodology and development of the model for stress and deformation state analysis of the connecting lug of container terminals. Numerical analysis was conducted by ...
Experimental determination of brittle fracturing appearance during static indentation of materials based on stone
(Springer Heidelberg, 2017)
During micro cutting process, the presence of both ductile and brittle mode is observed. The appearance of one or the other, or the value of critical penetration depth, when transition is happening, depends on the material ...
Oxidation behavior during prolonged service of boiler tubes made of 2.25Cr1Mo and 12Cr1Mo0.3V heat resistance steels
(Elsevier Science Bv, Amsterdam, 2016)
During service of thermal power plant (TPP) units, different components are exposed to high temperature due to technological cycle of TPP unit. Service lifetimes of these components, especially boiler heating surfaces, may ...
Model analysis of complex structures - advantages of physical sub-scaled model testing and shortcomings in physical model production
(Elsevier Science Bv, Amsterdam, 2018)
The possibilities of testing real constructions strength are often limited, especially in case of large constructions. Testing on the model, instead of the actual construction, results in a great saving of money and time. ...
Towards a unified and practical industrial model for prediction of hydrogen embrittlement and damage in steels
(Elsevier Science Bv, Amsterdam, 2016)
Bearing in mind the multiple effects of hydrogen in steels, the specific mechanism of hydrogen embrittlement (HE) is active, depending on the experimental conditions and numerous factors which can be grouped as environmental, ...
Thermalhydraulics of once-through steam boiler tubes revisited
(Department of Thermal Technology, Gliwice, Poland, Silesian University of Technology 2020, 2020)
The analysis of pressure changes in water and steam flow along the entire once-through steam boiler
tube system was carried out. An efficient advanced method is developed and presented for the
prediction of once-through ...
Methodology optimization tests of composite rotor blades of helicopters in extreme conditions
(DANUBIA Adria Symposium on Advances in Experimental Mechanics, 2018)
Wear simulation of the polymer based composite sliding bearings by means of ansys
(Faculty of Engineering, University of Kragujevac, 2019)
Polymer based composite sliding bearings are increasingly applied in many industries, due to their economic (usually low cost of production) and technical (good tribological properties) benefits. In order to predict their ...
Weibull probability distribution for reactor steel 20MnMoNi55 cleavage fracture in transition temperature
(Elsevier, Amsterdam, 2020)
This paper presents the results and methods used for determining of fracture toughness of reactor steel, denoted as 20MnMoNi55, typically used for structures working at low temperatures, in transition temperature area. In ...