Претраживање
Приказ резултата 11-20 од 203
Crack propagation in 3PB specimen made from welded joint
(Elsevier, Amsterdam, 2020)
Crack propagation in 3PB specimen has been investigated experimentally by using Digital Image Correlation (DIC) technique. For this purpose, specimens were taken from butt welded plates, made of P460NL1 micro-alloyed steel. ...
Dual Phase Austempered Ductile Iron - The Material Revolution and Its Engineering Applications
(Springer International Publishing Ag, Cham, 2020)
During the last few years, there has been an increased interest in improving the strength of ductile iron by means of heat-treating to obtain dual phase microstructures that enhance the properties found in the Austempered ...
Weibull probability distribution for reactor steel 20MnMoNi55 cleavage fracture in transition temperature
(Elsevier, Amsterdam, 2020)
This paper presents the results and methods used for determining of fracture toughness of reactor steel, denoted as 20MnMoNi55, typically used for structures working at low temperatures, in transition temperature area. In ...
Process Mapping of Glass Envelope Design of Geometrically Complex Form
(Springer International Publishing Ag, Cham, 2020)
The design and construction of glass facades is a very complex sector in the construction industry, whose multidisciplinary character is reflected in the application of new technologies of glass and glass facade production, ...
Analysis of SA 387 Gr. 91 welded joints crack resistance under static and impact load
(Elsevier Science Bv, Amsterdam, 2021)
This paper presents the results of experimental testing of crack resistance of specimens taken from a welded plate made of steel SA-387 Gr. 91, while taking into account different filler materials and welding procedures ...
Numerical analysis of the response of the rc flat slab building under seismic action
(fib. The International Federation for Structural Concrete, 2021)
Investigation of the behaviour of flat slab system has been intensified in the last years. Wide use of flat slab systems due to the fast construction and simplicity of formwork has as the results presence of flat slab ...
Algorithm for defining quality of base material for repair welding
(Institut za ispitivanje materijala, Beograd, 2021)
The paper shows the comparison of different methodologies for defining the quality of base material due for repair welding as one of the basic and initial problems during the repair of damaged parts or machine equipment. ...
Composite material selection for aircraft structures based on experimental and numerical evaluation of mechanical properties
(Elsevier Science Bv, Amsterdam, 2021)
In this paper determination of mechanical properties of composite material using experimental and numerical approach is presented. The mechanical properties of a laminate obtained in the experiment are used for verification ...
Numerical simulation of fatigue crack growth in AA6156 T6 panels
(Elsevier B.V., 2021)
Fatigue crack growth in a panel with 4 stringers and 3-clips, made of AA6156 T6, was modelled numerically using xFEM. The central crack of the length a=17 mm was propagated in the total of 91 steps (in each step crack ...
Thermalhydraulics of once-through steam boiler tubes revisited
(Department of Thermal Technology, Gliwice, Poland, Silesian University of Technology 2020, 2020)
The analysis of pressure changes in water and steam flow along the entire once-through steam boiler
tube system was carried out. An efficient advanced method is developed and presented for the
prediction of once-through ...