Search
Now showing items 181-190 of 206
Damage tolerance analysis of structural components under general load spectrum
(Faculty of Mechanical Engineering in Slavonski Brod, Faculty of Electrical Engineering in Osijek, Faculty of Civil Engineering in Osijek, 2012)
In this investigation fatigue behaviour of damaged structural components under cyclic loads constant amplitude and load spectrum is considered. Primary attention of this investigation is the establishment of computation ...
Application of Composite Construction and Demolition Debris in Heavy Metals Removal from Industrial Wastewater
(Thermal Science, 2023)
The utilization of construction and demolition debris in industrial wastewater treatment by sorption of Co2+ and Ni2+ ions was investigated. Selected waste composites are cost-effective and locally available, still their ...
Effect of elevated temperatures on mechanical properties of ultra high strength hot work tool steel h11
(Univ Zagreb Fac Mechanical Engineering & Naval Architecture, Zagreb, 2020)
This paper presents an experimental and numerical study into the influence of elevated temperatures on mechanical properties of the heat treated high quality hot work tool steel H11. This steel belongs to a group of alloyed ...
Printing parameter optimization of PLA material concerning geometrical accuracy and tensile properties relative to FDM process productivity
(Springer Nature, 2023)
High demand for part customization shifts industries toward AM technologies. Part customization in high-volume manufacturing is developed to its limits, whereas low-volume production using AM is still economically unjustified. ...
Printing orientation influence on tensile strength of PA12 specimens obtained by SLS
(Springer, 2023)
Selective laser sintering (SLS) is one of the additive manufacturing technologies dedicated to the production of high-quality parts with complex geometries. Here, polyamide 12 (PA12) is a commonly used material, for ...
Structural Integrity Assessment of Welded Pressure Vessel Produced of HSLA Steel
(Journal Iron Steel Research Editorial Board, Beijing, 2011)
Welded joint is a critical region of a welded structure. The operational safety of welded pressure equipment mostly depends on the behaviour of loaded weldments. Safety of welded structure is dependent on the properties ...
Crack Growth Rate Analysis of Stress Corrosion Cracking
(Univ Osijek, Tech Fac, Slavonski Brod, 2021)
A theoretical film rupture model was used for computational procedure to predict the crack growth rate within the Stress Corrosion Cracking (SCC) conditions. Chemical, electrochemical and mechanical aspects of the SCC were ...
Contemporary Maintenance Management of Power Plant Life Exhaustion Components
(Technics Technologies Education Management, 2010)
Reliability centered maintenance (RCM) has a key role in the quality system of thermal power plants. Electricity production is definitely not only production of a product, but also becomes a customer service. Reliability ...
Deformation mechanisms in ti3al-nb alloy at elevated temperatures
(Institute of Metals and Technology, 2010)
Ti3Al-11Nb-1V (x/%) was made in a vacuum arc furnace. Hot-rolling was conducted at 1050 degrees C in a two-phase field of the alloy. Strain-rate jump tests were performed at T = 800-1100 degrees C and strain rates of 10(-6) ...
Numerical study of transient three-dimensional heat conduction problem with a moving heat source
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2011)
A numerical study of transient three-dimensional heat conduction problem with a moving source is presented. For numerical solution Douglas-Gunn alternating direction implicit method is applied and for the moving heat source ...