Претраживање
Приказ резултата 1-10 од 10
Numerical analysis of a hypersonic turbulent and laminar flow using a commercial cfd solver
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
Computational fluid dynamics computations for two hypersonic flow cases using the commercial ANSYS FLUENT 16.2 CFD software were done. In this paper, an internal and external hypersonic flow cases were considered and ...
Experimental Investigation of the Efficiency of Heat Pump Drying System with Full Air Recirculation
(Wiley, Hoboken, 2017)
The paper presents results of an experimental investigation of convective drying of apples var. Idared, potatoes var. Desiree and bananas var. Grand Nein, in full recirculation laboratory-scale dryer. The experiments were ...
Two-dimensional numerical analysis of active flow control by steady blowing along foil suction side by different urans turbulence models
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
The effects of active separation control by steady blowing jets were investigated numerically on three different examples: subsonic flow past Aerospatiale A airfoil at 13 degrees angle-of-attack, transonic flow past NACA ...
Measurement of thermal emission during cutting of materials using abrasive water jet
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
This article deals with measurement of the thermal gradient on material during abrasive water jet cutting. The temperature was measured by thermocamera before the technological process started, during the abrasive water ...
Techno-economic evaluation of residue exhaustion in batch rectification ethanol production plant
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
This paper presents the techno-economic optimization of batch plant for production of rectified alcohol based on the concentration of ethanol in residue. The aim of the analysis was to determine the extent to which it is ...
Importance of on-time decision making in energy sector based on perspectives case study new stavalj project
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
Expression "Development conditions and perspectives" became important for numerous analyses in various industrial and social areas. Several strategic documents and studies in last two decades analysed projects with topics ...
CFD Calculation of Helicopter Tail Rotor Airloads for Fatigue Strength Experiments
(Asce-Amer Soc Civil Engineers, Reston, 2017)
This work focuses on defining loads and fatigue life estimation of helicopter tail rotor blades. The original metal construction of these blades was replaced with a new construction of blades made from composite materials. ...
Effect of material heterogeneity and constraint conditions on ductile fracture resistance of welded joint zones - Micromechanical assessment
(Pergamon-Elsevier Science Ltd, Oxford, 2017)
The topic of this work is assessment of ductile fracture initiation and development in different zones of welded joint of a high strength low alloyed (HSLA) steel. A combined experimental-numerical procedure is applied for ...
Experimental and analytical evaluation of preheating temperature during multipass repair welding
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2017)
Experimental measurement and analytical calculation of preheating, i.e. interpass temperature during multi-pass repair welding has been presented. Analytical calculation is based on heat transfer analysis, whereas measurements ...
Determination of Degradation Level during Cavitation Erosion of Zircon Based Ceramic
(Science of Sintering, 2017)
Mechanical shock of zircon based ceramic induced by cavitation erosion testing was investigated in this study. Several parameters were followed in order to determine level of material degradation during the cavitation ...