Претраживање
Приказ резултата 1-10 од 14
Effect of building direction and heat treatment on mechanical properties of Inconel 939 prepared by additive manufacturing
(Springer Nature, 2023)
This study investigated the effect of building direction (BD) and three-step heat treatment on the microstructure and mechanical properties of a nickel-based superalloy Inconel 939 produced by additive manufacturing (AM), ...
Development and Improvement of Numerical Models of Welded Joints with Multiple Defects
(Trans Tech Publications, 2023)
This paper presents the development of numerical models which were used to simulate
the behaviour of welded joints containing different combinations of multiple defects under tensile
loads. Four representative combinations ...
Printing orientation influence on tensile strength of PA12 specimens obtained by SLS
(Springer, 2023)
Selective laser sintering (SLS) is one of the additive manufacturing technologies dedicated to the production of high-quality parts with complex geometries. Here, polyamide 12 (PA12) is a commonly used material, for ...
Flexibility of power generation and possibilities for feasible upgrades of coal power plants: a case of the Electric Power Industry of Serbia
(Beograd : Društvo termičara Srbije, 2023)
This paper deals with current status and possibilities for feasible improvement of the flexibility of power generation fleet consisting of aged coal-fired power plants and hydro power plants. The analyses are done by use ...
Welding Joint Made of Two Different Austenitic Materials
(Materials Science Forum, 2023)
Using austenitic steel in welding structures requires both destructive and non-destructive testing (NDT) to approve the use of intended welding specification, but also testing of material properties, even if they are ...
The Main Factors that Determine the Company’s Innovations–Empirical Research of Companies in Serbia
(Springer, 2023)
In the constantly changing business environment, innovations enable companies to achieve competitiveness and expand to new markets. Measuring a company’s ability to innovate is important for both theoretical consideration ...
Manufacturing parameter influence on FDM polypropylene tensile properties
(Journal of Mechanical Science and Technology, 2023)
Polypropylene (PP) is a relatively new material in fused deposition modeling (FDM) technology. The main feature of this material is its ability to significantly elongate under applied load, unlike any other thermoplastic ...
Application of Composite Construction and Demolition Debris in Heavy Metals Removal from Industrial Wastewater
(Thermal Science, 2023)
The utilization of construction and demolition debris in industrial wastewater treatment by sorption of Co2+ and Ni2+ ions was investigated. Selected waste composites are cost-effective and locally available, still their ...
Analysis of remediation of horizontal cylindrical tank for oil storage
(Akademija tehničkih strukovnih studija Beograd, 2023)
The paper deals with the problems related to the horizontal cylindrical tank with capacity 52m3 for oil storage, which is in long time continual service. Before planned change of location necessary planned cleaning and ...
UTILIZATION OF THE FLUE GAS WASTE HEAT BY THE LOW-PRESSURE ECONOMIZER AT 350 MWE LIGNITE-FIRED POWER PLANT
(Beograd : Društvo termičara Srbije, 2023)
Potential for the waste heat utilization in coal-fired thermal power plants that are in operation for a long period is reflected in an increased temperature of the flue gas at the exit of the regenerative air heater. After ...