Pretraživanje
Prikaz rezultata 11-20 od 34
New types of protective coatings and development of test methods
(Structural integrity and life, 2023)
The paper presents the results of synthesis and charac-terisation of refractory coatings based on various fillers intended for the protection of metallic structures. Refractory fillers applied are based on mullite, cordierite, ...
Printing orientation influence on tensile strength of PA12 specimens obtained by SLS
(Springer, 2023)
Selective laser sintering (SLS) is one of the additive manufacturing technologies dedicated to the production of high-quality parts with complex geometries. Here, polyamide 12 (PA12) is a commonly used material, for ...
Impact of residual stress on integrity of the vessel for methanol storing
(Društvo za integritet i vek konstrukcija „Prof. dr Stojan Sedmak“, 2023)
The purpose of this paper is to present impact of the improper choice of the procedure for repairing of pressure vessel for methanol storage, which finally could leads even to its failure. Represented information are based ...
Development and Improvement of Numerical Models of Welded Joints with Multiple Defects
(Trans Tech Publications, 2023)
This paper presents the development of numerical models which were used to simulate
the behaviour of welded joints containing different combinations of multiple defects under tensile
loads. Four representative combinations ...
Oily-water tank operational reliability analysis in an oil and gas facility
(Društvo za integritet i vek konstrukcija „Prof. dr Stojan Sedmak“, 2023)
The paper deals with one of the most general classifica-tions of atmospheric tanks according to their roof type in oil and gas plants. An overview of recommended time frames for inspection of storage tanks is given, depending ...
Impact of residual stress on integrity of the vessel for methanol storing
(Društvo za integritet i vek konstrukcija „Prof. dr Stojan Sedmak“, 2023)
The purpose of this paper is to present impact of the improper choice of the procedure for repairing of pressure vessel for methanol storage, which finally could leads even to its failure. Represented information are based ...
Manufacturing parameter influence on FDM polypropylene tensile properties
(Journal of Mechanical Science and Technology, 2023)
Polypropylene (PP) is a relatively new material in fused deposition modeling (FDM) technology. The main feature of this material is its ability to significantly elongate under applied load, unlike any other thermoplastic ...
Selective laser sintered Pipe Ring Notched Tension specimens for examination of fracture properties of pipeline materials
(Engineering Fracture Mechanics, 2023)
In order to develop a non-standard method for determining the resistance to fracture and damage of pipeline materials, a new geometry of ring-shaped specimens with sharp notches or cracks has been defined. The need to ...
Hydroxyapatite-based dental inserts: Microstructure, mechanical properties, bonding efficiency and fracture resistance of molars with occlusal restorations
(Wiley, 2023)
This study aimed to (1) comparatively analyze properties of Sr- and Mg-substituted hydroxyapatite (HAP)-based dental inserts; (2) evaluate insert bonding to restorative materials, and (3) evaluate the effect of doped HAP ...
The influence of material infill on ABS-X flexural strength
(Springer, 2023)
This paper contains a comparison of the flexural strength results of two different samples. Both samples were made using additive manufacturing, from ABS (acrylonitrile butadiene styrene) material with the inclusion of an ...