Претраживање
Приказ резултата 11-20 од 24
Modeling of the buckstay system of membrane walls in watertube boiler construction
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
Membrane walls are very important structural parts of water-tube boiler construction. Based on their specific geometry, one special type of finite element was defined to help model the global boiler construction. That is ...
Isogeometric bending analysis of composite plates based on a higher-order shear deformation theory
(Korean Soc Mechanical Engineers, Seoul, 2014)
This research paper presents an isogeometric plate finite element formulation for analysis of thick composite plates. Isogeometric finite element method which is based on non-uniform rational B-splines (NURBS) basis ...
The failure analysis of the star-separator of an aircraft cannon
(Pergamon-Elsevier Science Ltd, Oxford, 2014)
This paper analyzes the causes of fracture of the double pipe aerial cannon stellate starseparator, which occurred during the fighting plane mission. The linear finite element method (FEM) is used to determine the stresses ...
The performance of pip-cascade controler in hvac system
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
Primitive controllers used in the early version for HVAC systems, like the on-off (Bang-Bang) controller, are inefficient, inaccurate, unstable, and suffer from high-level mechanical wear. On the other hand, other controllers ...
Impact of choice of stabilized hysteresis loop on the end result of investigation of high-strength low-alloy (hsla) steel on low cycle fatigue
(Faculty of Metallurgy, 2014)
High strength low-alloy steel under low cycle fatigue at a certain level of strain controlled achieve stabilized condition. During the fatigue loading stabilized hysteresis loop is determined, which typical cycle of ...
Determining the theoretical reliability function of thermal power system using simple and complex weibull distribution
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
The main subject of this paper is the representation of the probabilistic technique for thermal power system reliability assessment. Exploitation research of the reliability of the fossil fuel power plant system has defined ...
Thermomechanics of soft inelastics bodies with application to asphalt behavior
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
Thermomechanical behavior of hot mix asphalt (HMA) is considered. Its highly irregular microstructure is covered by the hierarchical approach. A brief survey of endochronic thermodynamics precedes constitutive consideration. ...
Influence of friction stir welding parameters on properties of 2024 t3 aluminium alloy joints
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
The aim of this work is to analyse the process of friction stir welding (FSW) of 3 mm thick aluminium plates made of high strength aluminium alloy - 2024 T3, as well as to assess the mechanical properties of the produced ...
Numerical analysis of temperature field during hardfacing process and comparison with experimental results
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2014)
The three-dimensional transient nonlinear thermal analysis of the hard facing process is performed by using the finite element method. The simulations were executed on the open source Salome platform using the open source ...
Identification of low cycle fatigue parameters of high strength low-alloy (hsla) steel at room temperature
(Croatian Metallurgical Soc, Zagreb, 2014)
Low cycle fatigue test was performed in ambient atmosphere at room temperature. cycle loading of material, in case of High strength low-alloy steel, entails modifications of its properties and in this paper is therefore ...