Претраживање
Приказ резултата 31-40 од 44
Assessment of Grain Size and Grain Refinement Efficiency by Calculation of Released Heat Attributed to Formation of Primary Aluminum Crystals During Solidification of Al7Si4Cu Alloy
(Springer India, New Delhi, )
Assessing heat released only related to the formation of primary crystals provides results with a significantly higher sensitivity than a traditional assessment of undercooling value. In this work, two similar Ti5B1 master ...
A Theoretical Model for Vibro-Impact Dynamics of Spur Gears with Tooth Flanks Wear
(Springer Nature, 2020)
The main performance of involute gears operation leads to the appearance of nonlinear dynamic behavior and impact. In this chapter the influence of mild wear of the tooth flanks of gears without machine finishing and surface ...
Defects in casting caused by hyman error
(3rd International Symposium of Natural Resources Management, Zaječar 30-31 May 2013, Proceedings, 2013)
This paper analysed the influence of various factors on moulding discontinuities and moulding quality. The research established that most causes were rooted in a casting process itself, such as: the method of alloy ...
Design of the breeder zone for the eu helium cooled pebble bed test blanket module for iter
(Proceedings - Symposium on Fusion Engineering, 2009)
This paper summarizes the design and development activities for the EU Helium Cooled Pebble Bed Test Blanket Module (HCPB TBM) Breeder Zone (BZ) performed in 2007 and 2008. The BZ design, based on two parallel cooling ...
Improvement of environment quality by the arsenic phytoremediation from ashes
(Faculty of Mechanical Engineering and Naval Architecture, Zagreb, 2014)
The objective of this paper is to investigate possibility of environment quality improvement of
landfill ashes by a new technology of phytoremediation. The research included an analysis of
the adsorption of arsenic, ...
Management of water quality in reservoirs in correlation with environment
(Faculty of Mechanical Engineering and Naval Architecture, Zagreb, 2014)
The main objective for the conducted research presented in this paper was to quantify, analyze
reversibility of the algal bloom process and present changes in water quality parameters in the
function of time, depth and ...
Sustainable Environmental Policy and Organisation of Ecology Campus
(Faculty of Mechanical Engineering and Naval Architecture, Zagreb, 2014)
The main goal of this paper was to pay attention on possibilities and advantages of clean solar
energy using in the ecology campus, as an isolated system, with the respect to the intachable
environment. The mini solar ...
Mathematical modeling and experimental investigation of a composite beam failure - Case study
(London : Sage Publications Ltd, 2023)
Composite materials have been extensively employed in the aviation industry in recent years. The application of new materials enables significant weight savings with improved mechanical characteristics. This is also very ...
The use of non-contact optical systems for determination of fracture mechanics parameters
(Welding and Material Testing, 2014)
Structural Integrity Assessment of Welded Pressure Vessel Produced of HSLA Steel
(Journal Iron Steel Research Editorial Board, Beijing, 2011)
Welded joint is a critical region of a welded structure. The operational safety of welded pressure equipment mostly depends on the behaviour of loaded weldments. Safety of welded structure is dependent on the properties ...