Претраживање
Приказ резултата 21-30 од 30
A Heat Conduction and Convection Analytical Benchmark for Adjoint Solution Verification of Computational Fluid Dynamics Codes Used in Reactor Design
(Amer Nuclear Soc, La Grange Pk, 2016)
This work presents a heat transport benchmark problem when modeling the steady-state radial conduction in a fuel rod coupled to the axial heat convection in a coolant surrounding the rod and flowing along it. This benchmark ...
Analysis of the nominal load effects on gear load capacity using the finite-element method
(Sage Publications Ltd, London, 2010)
This research investigates the effects of the nominal load value on load distribution of simultaneously meshing gear teeth pairs, and on the involute gear load capacity. The research results presented in this article confirm ...
Non destructive monitoring of cavitation erosion of cordierite based coatings
(Composites Part B: Engineering, 2016)
Coating materials are widely used in refractory lining to prevent different deleterious effects such are reactions on the mold-metal contact surface, abrasion from liquid metal or alloy, gasses, slags, and other materials ...
Mathematical modeling and experimental investigation of a composite beam failure - Case study
(London : Sage Publications Ltd, 2023)
Composite materials have been extensively employed in the aviation industry in recent years. The application of new materials enables significant weight savings with improved mechanical characteristics. This is also very ...
The use of non-contact optical systems for determination of fracture mechanics parameters
(Welding and Material Testing, 2014)
Structural Integrity Assessment of Welded Pressure Vessel Produced of HSLA Steel
(Journal Iron Steel Research Editorial Board, Beijing, 2011)
Welded joint is a critical region of a welded structure. The operational safety of welded pressure equipment mostly depends on the behaviour of loaded weldments. Safety of welded structure is dependent on the properties ...
Assessment of Grain Size and Grain Refinement Efficiency by Calculation of Released Heat Attributed to Formation of Primary Aluminum Crystals During Solidification of Al7Si4Cu Alloy
(Springer India, New Delhi, )
Assessing heat released only related to the formation of primary crystals provides results with a significantly higher sensitivity than a traditional assessment of undercooling value. In this work, two similar Ti5B1 master ...
The Influence of Modifying Methods on the Quality of Eutectic and Hypereutectic Silumine for Diesel Engine Pistons
(International Journal of Cast Metals Research, 2013)
The results of the investigation of the influence of different modifiers (sodium, phosphorus, antimony and strontium) on the quality of AlSi12CuMgNi and AlSi18CuMgNi alloys, which are used for the production of pistons, ...
Efekti delovanja plazme na poboljšanje svojstava odlivaka aluminijuma za autoindustriju
(Zenica : IPI – ''INSTITUT ZA PRIVREDNI INŽENJERING'', 2015)
Mlaz plazme znatno modifikuje tretiranu površinu odlivaka legura aluminijuma. Korišćenje
kvazistacionarnih mlazeva plazme za modifikaciju površine omogućilo je znatno povećanje tvrdoće
površine tretiranih uzoraka. ...
Comparison of cavitation erosion behavior od cordierite and zircon based samples using image and morphological analyses
(Materials Letters, 2018)
In this study the resistance of cordierite and zircon to the cavitation erosion was investigated with the aim of possible spreading their application. Cavitation erosion test was applied using standard ultrasonic vibratory ...