Претраживање
Приказ резултата 1-9 од 9
Optimization of the Unloading Bridge Working Cycle
(Strojniski Vestnik/Journal of Mechanical Engineering, 2009)
This paper presents one of the possible ways of optimization of unloading bridge working cycle i.e. minimization of: energy consumption, material dissipation during the grab discharging, rope incline angle etc. Optimization ...
Development of a model for optimization of central heating system selection
(Technics Technologies Education Management, 2011)
A choice of central heating system, when designing the new residential building or adapting the existing one, is one of the most important activities regarding various aspects. This paper presents one approach to designing ...
A model for gear shifting optimization in motor vehicles
(Transactions of Famena, 2012)
This paper presents an implemented idea for gear shifting optimization with the aim of fuel consumption minimization. A new combined theoretical and experimental approach has been developed using the On-Board Diagnostic ...
Optimum design of thin-walled i-beam subjected to stress constraint
(Polish Society of Theoretical and Allied Mechanics, 2012)
This paper deals with the problem of optimization of a thin-walled open section I-beam loaded in a complex way, subjected to the bending, torsion and constrained torsion. A general case of bending moments about two centroidal ...
Korišćenje metode diskretnih elemenata na modelovanje pužnih transportera-miksera / Discrete element modelling of screw conveyor-mixers
(Savez hemijskih inženjera, Beograd, 2015)
Pužni transporteri se veoma intenzivno koriste u industriji za proizvodnju i preradu hrane, plastike, mineralnih sirovina, u poljoprivrednoj proizvodnji kao i u prerađivačkoj industriji za podizanje i/ili transport rasutih ...
Numerical analyses of a hydraulic hybrid powertrain system for a transit bus
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2020)
A dynamic programming optimization algorithm has been applied on a transit bus model in MATLAB in order to assess the fuel economy improvement potential by implementing a hydraulic hybrid powertrain system. The numerical ...
Analysis of the performance of a low-power atmospheric burner for gas appliances for households and their impact on the emission and stability of the burner
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2021)
The paper presents results of theoretical numerical research dealing with CO and NOx emission performed in the process of optimization of the performance of low-power atmospheric burners. The theoretical part of this paper, ...
Optimization of multistage turbines using a through-flow code
(Professional Engineering Publishing Ltd, Bury St Edmunds, 2001)
Fast and accurate flow calculation and performance prediction of multistage axial flow turbines at design and off-design conditions were performed using a compressible steady state inviscid through-flow code with high ...
An Approach to the Optimization of a Thin-walled Z-beam
(Strojniski Vestnik/Journal of Mechanical Engineering, 2009)
One approach to the optimization of a thin-walled open section Z-beam subjected to bending and to the constrained torsion is considered. For given loads, material and geometrical characteristics the problem is reduced to ...