Претраживање
Приказ резултата 11-20 од 25
The use of 3D printing for studying the influence of ionizing radiation on electronic components
(SIRAMM project - H2020-WIDESPREAD-2018-03 Project No. 857124, Horizon 2020, 2021)
The application of additive technology gives a designer more freedom in designing and defining the optimal product design. Also, it is possible to make a model with different materials that have different mechanical ...
Аdvanced quality management model ISO 9001:2015 – challenges and opportunities
(United Association of Serbia for Quality - UASQ, 2014)
Business standardization developed intensely in the second decade of the 21st century. In late 2012 (31st December) there were: (i) 1504213 certificates to ISO 9001, 13485, 14001, 16949, 22000, 27001 and 50001 in the world, ...
Internality of truncated averaged Gaussian quadratures
(Department of Mathematics, Faculty of Science, Akdeniz University,Turkey, 2018)
When moments or modi ed moments of the weight function are difficult to
compute, generalized averaged Gaussian quadratures can serve as good substitutes.
These formulas were introduced by Spalević [3], where it was ...
Influence of wall layer number around brass inserts in 3D printed specimens subjected to axial pull-out force
(SIRAMM H2020-WIDESPREAD-2018-03 Project No. 857124, Horizon 2020, 2022)
The use of threaded inserts embedded in plastic parts is very common in variety of industries including electronics, automotive, aerospace, medical, transportation, defense etc., particularly where frequent assembly and ...
An analysis of the Different Parameters influence on the Microbearing load carrying capacity
(International Association for Applied Mathematics and Mechanics, Nemačka, 2014)
An analytical solution for the two-dimensional non-isothermal compressible gas flow in a slider micro-bearing is presented in this paper. It is shear-driven subsonic slip gas flow. In view of the fact that a fluid flow in ...
Importance of number of hyperactivated spermatozoa for successful fertilisation trough mechanical oscillatory model of mouse zona pellucida
(Beograd : Udruženje za reproduktivno zdravlje, 2013)
The quality of a whole ejaculate is important for fertilization success. Number of
sperm with effective swimming velocity, capable to reach the oocyte and to undergo
complex adaptations within the female reproductive ...
DEEP LEARNING IN PIV APPLICATIONS
(2023)
In the last decades, the field of fluid dynamics has evolved significantly thanks to the
development of experimental and measurement techniques (hot wire, LDA, PTV, PIV), as well as
the increasing computational capabilities ...
Non-isothermal gas flow in microchannel with equal wall temperatures
(Gesellschaft für Angewandte Mathematik und Mechanik, Republika Srbija, 2013)
A non-isothermal pressure-driven compressible subsonic slip gas flow in microchannels with variable cross section (convergent, divergent and constant high channel) is analyzed in this paper analytically. Since the flows ...
Skin layers characterisation by fractional bioimpendace
(Belgrade : Institute of Technical Sciences of the Serbian Academy of Sciences, 2010)
Bioelectro-mechanical properties of skin can be very valid data for analyzing fractal
characteristics of skin structure. In this paper, bioelectrical impedance method and fractional
calculus have been utilized for the ...
Stereoscopic PIV Measurements and Visualization of a Turbulent Swirl Flow behind an Axial Fan in a Pipe
(University of Belgrade, Faculty of Mechanical Engineering, Chair of Fluid Mechanics, 2011)
In this paper are presented experimental results obtained in circular pipe behind axial fan for Reynolds numbers 0.6 till 3.56�����105.
Stereo Particle Image Velocimetry (Stereo PIV), original classical probes and flow ...