Претраживање
Приказ резултата 31-40 од 347
Experimental determination of airflow resistance coefficient of porous plates for fly ash air-slide pneumatic transport
(Assoc Textile Engineers Technicians Croatia, Zagreb, 2009)
Different porous materials are Used for the transport of discharged fly ash from electrostatic precipitator in air-slide pueumatic conveying system The knowledge of physical, mechanical as well as flow properties of these ...
Micromechanical estimates of the critical values of j-integral for the steel of steam pipelines
(Springer, New York, 2009)
We analyze the level of damage to 14MoV63 steel for steam pipelines under the conditions of crack-growth initiation according to the mechanism of ductile fracture. The state of the material after service for about 100,000 ...
Transition temperature and fracture mode of as-castand austempered ductile iron
(Wiley, Hoboken, 2008)
The ductile to brittle transition temperature is a very important criterion that is used for selection of materials in some applications, especially in low-temperature conditions. For that reason, in this paper transition ...
HELIO code prediction of hydrogen accumulation in non-vented steam pipelines
(Elsevier Science Sa, Lausanne, 2006)
The thermal-hydraulic and physico-chemical code HELIO is developed for numerical simulations and analyses of radiolytic gases (hydrogen and oxygen) accumulation in non-vented steam pipelines of nuclear power plant systems. ...
Temperature and radiation hardness of polycarbonate capacitors
(National Institute of Optoelectronics, 2007)
The aim of this paper is to examine the influence of temperature raising, as well as neutron and gamma irradiation on the dissipation factor (loss tangent, tg delta) and capacitance (C) of capacitors with polycarbonate ...
Wear behaviour of ti6al4v alloy against al2o3 under linear reciprocating sliding
(Journal of the Balkan Tribological Association, 2011)
Tribological behaviour of four different heat-treated Ti6Al4V alloys, during linear reciprocating sliding against alumina, on the microscale was investigated. Experiments were carried out for dry sliding and in the Ringer ...
Application of the residual strength degradation model to carbon-epoxy composite
(Consultants Bureau/Springer, New York, 2008)
A residual strength degradation model for two orientations of fibers of carbon-epoxy composite is proposed. The model is constructed on the basis of an analysis of a gradual decrease in the residual strength of the composite ...
Dynamic Compensation of Electrical Runout in Eddy Current Contactless Measurements of Non-Stationary Ferromagnetic Target
(Amer Scientific Publishers, Stevenson Ranch, 2009)
Industrial measuring systems nowadays are frequently based on eddy current sensors. These sensors are highly accurate, with high resolution, have good bandwidth and they are very robust against contamination in an industrial ...
Artificial technologies in sustainable braking system development
(Inderscience Enterprises Ltd, Geneva, 2008)
Traditional product development process is costly and time-consuming. It requires system components being fabricated, assembled and tested. Systems-engineering based sustainable development enables optimised solutions to ...
Oxygen transfer efficiency of the aeration process in refinery waste water treatment
(Syscom 18 S.R.L., 2008)
This paper presents the results of an experimental investigation of aeration of water with a corresponding mass concentration of waste motor oil depending on the height of the liquid column for varied flow of air introduced ...