Претраживање
Приказ резултата 31-40 од 421
The impact of worn out tool on the character and type of chip formation
(Institute of Mechanical Engineering, 2009)
Security of gas pipelines
(Springer, Dordrecht, 2009)
Security of the natural gas supply strongly depends on the integrity of the transportation pipelines. The statistical evidence shows that the most probable cause of the break occurrence at natural gas pipeline is the ...
Numerička analiza loma zatezne epruvete sa prslinom u ZUT / Numerical analysis of tensile specimen fracture with crack in HAZ
(Kluwer Academic Publishers, 2006)
Numeričkim rešenjima se omogućava istraživanje složenijih problema, uključujući analizu pojedinačnih uticaja, posebno u slučajevima kada izostaju odgovarajući eksperimenti i matematička rešenja usled visoke cene, složenosti ...
Ash from thermal power plants as secondary raw material
(Arhiv za Higijenu Rada i Toksikologiju, 2007)
The basic characteristic of thermal power plants in the Republic of Serbia is that they use low-grade brown coal (lignite) as a fuel. Depending on the location of coal mines, lignite may have different properties such as ...
Experimental determination of J-integral at elevated temperatures
(17th European Conference on Fracture 2008: Multilevel Approach to Fracture of Materials, Components, 2008)
In past two decades, the development of 9-12% Cr creep-resistant steel for critical components in coal-fired power stations that can withstand higher temperatures and pressures has been intensified in order to increase ...
Structural integrity assessment by local approach to fracture
(Kluwer Academic Publishers, 2006)
Failure analysis of block brake unit support of EMU
(Institute of Mechanical Engineering, 2009)
Evaluation of damage of steam pipeline steel using local approach to fracture
(American Society of Mechanical Engineers, Pressure Vessels and Piping Division (Publication) PVP, 2008)
In the paper, the level of damage of steam pipeline steel after about 100,000 hours at 540°C (1004 °F) under pressure of 42 bars (609 PSI) is analyzed. Material degradation is estimated using a combined experimental and ...
Visualization of submerged cavitating jet: Part one -the phenomenon, time-synchronization, photo objectives and sono-luminescence
(Proceedings of the 16th Australasian Fluid Mechanics Conference, 16AFMC, 2007)
In order to study the jet structure and the behavior of cloud cavitation within time and space, visualization of highly submerged cavitating water jet has been done using 4-Quik-05 camera. This included obligatory ...
Visualization of submerged cavitating jet: Part two - Influences of hydrodynamic conditions, nozzle geometry and visualization system arrangement
(Proceedings of the 16th Australasian Fluid Mechanics Conference, 16AFMC, 2007)
In visualization results of highly-submerged cavitating water jet obtained by a digital camera, the influence of parameters such as: injection pressure, nozzle diameter and geometry, nozzle mounting (for convergent / ...