Претраживање
Приказ резултата 1-10 од 910
Design and manufacture of reformer in polymer electrolyte membrane fuel cell
(Institut za ispitivanje materijala, Beograd, 2017)
The paper describes the development and manufacturing aspects of the reformer in polymer electrolyte membrane (PEM) fuel cell, from the first step of realization that includes modelling the main parts of the reformer; ...
Determination of bond strength between the hard-faced (HF) layer and the base material (BM) of forging dies
(Faculty of Metallurgy, 2016)
This paper points out complex working conditions of forging dies, which are the most frequent causes of their damage, and proposes suitable hard-facing repair procedures. The shear strength between the hard-faced layer and ...
The effect of cracks on stress state in crane wheel hard-surface under contact loading
(Univ Osijek, Tech Fac, Slavonski Brod, 2017)
Shown in this paper are the results of microstructure testing of crane wheels, along with the repair welding procedure performed by hard-surfacing. Repair welding involved the application of a welded layer to the crane ...
The economic sustainability of a model that balances ecological and power supply needs
(MM publishing Ltd., 2017)
Energy from biomass have a number of good features. These crops have a positive effect on the environment, ecology and environmental protection because they serve as a means of rebuilding the degraded area. This paper ...
Fenomen misije u srpskim kompanijama / The phenomenon of mission in Serbian companies
(Univerzitet u Beogradu - Tehnički fakultet u Boru, Beograd, 2019)
Izjava o misiji je personifikacija identiteta organizacije i služi kao osnova za sve zaposlene da se identifikuju sa organizacijom. Dobro definisana misija obezbeđuje stabilnost organizacije jer daje jasan pravac kretanja ...
The impact of the temperature and exploitation time on the tensile properties and plain strain fracture toughness, K-Ic in characteristic areas of welded joint
(Gruppo Italiano Frattura, Cassino, 2018)
This paper presents the analysis of the temperature and exploitation time impact on the resistant measure to brittle fracture of welded joint constituents of the new and exploited low-alloyed Cr-Mo steel A-387 Gr. B from ...
Application of a mathematical model for container transport flow of goods: from the far east to Serbia
(Univ Osijek, Tech Fac, Slavonski Brod, 2016)
Container transport represents a key component of intermodal transport and a substantial contribution to the rapidly growing international trade. The container trade should be optimal to provide a suitable resource utilisation ...
Expectations, reality and perspectives in using bim for the green building design
(Institut za ispitivanje materijala, Beograd, 2017)
In the late 1970s when the first programs for building energy consumption simulation appeared, architectural practice was based on paper documentation and 2D drafting programs were considered as state of the art technologies. ...
Possibilities of predicting the behaviour of ferrite-austenite welded joints in pressure equipment during exploitation
(Univ Osijek, Tech Fac, Slavonski Brod, 2017)
Exploitation safety of pressure equipment depends, among other factors, on the possibility of predicting the behaviour of each of its components during exploitation. If the safety of analysis is oriented towards materials ...
Effect of aging on mechanical properties of Al-8Si-8Fe-1.4v/SiCp composites
(Faculty of Metallurgy, 2016)
In this study, Al-8Fe-8Si-1.4V/SiCp composites fabricated by squeeze casting process were age-hardened to Study the influence of heat treatment on mechanical properties, such as hardness, bending strength and modulus of ...