Претраживање
Приказ резултата 51-57 од 57
Fracture analysis of the pulley of a bucket wheel boom hoist system
(Polish Maintenance Soc, Lublin, 2016)
This paper presents the results of the pulley fracture analysis. Experimental investigations confirmed that the chemical composition and basic mechanical properties of the pulley material, except the impact energy at a ...
Best Practices of Biomass Energy Life Cycle Assessment and Possible Applications in Serbia
(Zagreb Univ, Fac Forestry, Zagreb, 2016)
This paper aims to highlight the advantages of using Life Cycle Assessment (or LCA) tool in energy sector for rational energy consumption, selection of green technologies and process optimization. Besides the definition ...
Determination of bond strength between the hard-faced (HF) layer and the base material (BM) of forging dies
(Faculty of Metallurgy, 2016)
This paper points out complex working conditions of forging dies, which are the most frequent causes of their damage, and proposes suitable hard-facing repair procedures. The shear strength between the hard-faced layer and ...
3D Digital Image Correlation Analysis of the Shrinkage Strain in Four Dual Cure Composite Cements
(Hindawi Ltd, London, 2019)
The introduction of resin-based cements and an adhesive-bonding system in daily dental practice has given the opportunity to increase the retention of previously conventional cemented restorations and the optimal results ...
Numerical simulation of tensile testing of pe 80 polymer specimens
(Univerzitet u Beogradu - Institut za nuklearne nauke Vinča, Beograd, 2018)
The aim of this paper is to present the behaviour of specimens made of polyethylene material PE 80, subjected to tensile load until failure. Measurements of the temperature distribution have been done using the infrared ...
Novel Method for Measurement of Pipeline Materials Fracture Resistance-Examination on Selective Laser Sintered Cylindrical Specimens
(International Institute for the Science of Sintering, 2022)
This paper presents a part of development of a non-standard method for testing of cylindrical test specimens for measurement of fracture properties of pipeline materials. This method for testing of cylindrical structures ...
Effects of Multiple Defects on Welded Joint Behaviour under the Uniaxial Tensile Loading: Fem and Experimental Approach
(MDPI, 2023)
The research represents the ongoing investigation of the welded joints behavior made
of low-carbon low-alloyed steel in the presence of different multiple defects. Following the initial
experimental and numerical analyses ...