Pretraživanje
Prikaz rezultata 1-10 od 39
Color measurement of food products using CIE l*a*b* and RGB color space
(Consulting and Training Center KEY, 2013)
Color of the food is the first parameter of quality evaluated by consumers. What is important is the acceptance of the product even before being consumed. Inspection of food products is done using machine vision, particularly ...
Effect of building direction and heat treatment on mechanical properties of Inconel 939 prepared by additive manufacturing
(Springer Nature, 2023)
This study investigated the effect of building direction (BD) and three-step heat treatment on the microstructure and mechanical properties of a nickel-based superalloy Inconel 939 produced by additive manufacturing (AM), ...
Probability distribution on cleavage fracture in function of Jc for reactor ferritic steel in transition temperature region
(Engineering Failure Analysis, 2021)
This paper presents the results and methods used for determining of probability of cleavage fracture toughness of ferritic reactor steel in transition temperature area. The steel tested in this study is steel know as ...
The effect of expolatation conditions on the damage of a roller reducer totthed shaft and its repair
(10th International Symposium Machine and Industrial Design in Mechanical Engineering (KOD 2018), 2018)
Exergy efficiency of solar components and systems
(University of Niš, Faculty of Mechanical Engineering in Niš, 2017)
The solar energy is an inexhaustible source of energy and offers many environmental advantages compared to conventional energy sources. This paper deals with exergy efficiency of solar systems. The exergy is the measure ...
Deformation Mechanisms in Ti3Al-Nb Alloy at Elevated Temperatures
(Materiali in Tehnologije (Materials and technology), 2010)
Influence of Thickness Ratio on the Aerodynamic Characteristics of a Family of Hybrid Semielliptical Dolphin Airfoils
(Springer Nature Switzerland AG, 2024)
Development and Improvement of Numerical Models of Welded Joints with Multiple Defects
(Trans Tech Publications, 2023)
This paper presents the development of numerical models which were used to simulate
the behaviour of welded joints containing different combinations of multiple defects under tensile
loads. Four representative combinations ...
Welding Joint Made of Two Different Austenitic Materials
(Materials Science Forum, 2023)
Using austenitic steel in welding structures requires both destructive and non-destructive testing (NDT) to approve the use of intended welding specification, but also testing of material properties, even if they are ...
UTILIZATION OF THE FLUE GAS WASTE HEAT BY THE LOW-PRESSURE ECONOMIZER AT 350 MWE LIGNITE-FIRED POWER PLANT
(Beograd : Društvo termičara Srbije, 2023)
Potential for the waste heat utilization in coal-fired thermal power plants that are in operation for a long period is reflected in an increased temperature of the flue gas at the exit of the regenerative air heater. After ...