Претраживање
Приказ резултата 1-10 од 195
Composite material selection for aircraft structures based on experimental and numerical evaluation of mechanical properties
(Elsevier Science Bv, Amsterdam, 2021)
In this paper determination of mechanical properties of composite material using experimental and numerical approach is presented. The mechanical properties of a laminate obtained in the experiment are used for verification ...
Numerical simulation of fatigue crack growth in AA6156 T6 panels
(Elsevier B.V., 2021)
Fatigue crack growth in a panel with 4 stringers and 3-clips, made of AA6156 T6, was modelled numerically using xFEM. The central crack of the length a=17 mm was propagated in the total of 91 steps (in each step crack ...
Thermalhydraulics of once-through steam boiler tubes revisited
(Department of Thermal Technology, Gliwice, Poland, Silesian University of Technology 2020, 2020)
The analysis of pressure changes in water and steam flow along the entire once-through steam boiler
tube system was carried out. An efficient advanced method is developed and presented for the
prediction of once-through ...
Dual Phase Austempered Ductile Iron - The Material Revolution and Its Engineering Applications
(Springer International Publishing Ag, Cham, 2020)
During the last few years, there has been an increased interest in improving the strength of ductile iron by means of heat-treating to obtain dual phase microstructures that enhance the properties found in the Austempered ...
Design Aspects of Hip Implant Made of Ti-6Al-4V Extra Low Interstitials Alloy
(Elsevier Science Bv, Amsterdam, 2020)
The main concerns in design of hip implants are fracture and fatigue related issues. In this paper, reverse engineering is used to redesign a hip implant produced by precision casting, using Ti6Al4V Extra Low Interstitials ...
Extended FEM analysis of fatigue crack growth in Ti-6Al-4V orthopaedic plates
(Elsevier, Amsterdam, 2020)
The extended finite element method (xFEM) was used to analyse fatigue crack growth in orthopaedic locking compression plates (LCP), made of Titanium alloy, Ti-6Al-4V, loaded in four-point bending. The optimal geometry was ...
Weibull probability distribution for reactor steel 20MnMoNi55 cleavage fracture in transition temperature
(Elsevier, Amsterdam, 2020)
This paper presents the results and methods used for determining of fracture toughness of reactor steel, denoted as 20MnMoNi55, typically used for structures working at low temperatures, in transition temperature area. In ...
Process Mapping of Glass Envelope Design of Geometrically Complex Form
(Springer International Publishing Ag, Cham, 2020)
The design and construction of glass facades is a very complex sector in the construction industry, whose multidisciplinary character is reflected in the application of new technologies of glass and glass facade production, ...
Numerical analysis of the response of the rc flat slab building under seismic action
(fib. The International Federation for Structural Concrete, 2021)
Investigation of the behaviour of flat slab system has been intensified in the last years. Wide use of flat slab systems due to the fast construction and simplicity of formwork has as the results presence of flat slab ...
Algorithm for defining quality of base material for repair welding
(Institut za ispitivanje materijala, Beograd, 2021)
The paper shows the comparison of different methodologies for defining the quality of base material due for repair welding as one of the basic and initial problems during the repair of damaged parts or machine equipment. ...