Претраживање
Приказ резултата 1-10 од 30
Finite element modeling of pressure vessel with two internal surface crack
(11th International Conference on Fracture 2005, ICF11, 2005)
This paper deals with the finite element modeling of the pressure vessel with two artificial internal surface cracks, one positioned in the vessel center and the other one close to the vessel cover. Cracks are made by ...
Effects of structure characteristics on mechanical properties of aluminum alloy matrix composites
(Trans Tech Publications Ltd, 2004)
Composite materials based on the CW67 alloy (Al base matrix) and volume fraction of 15 pet of SiC particles in two nominal sizes (0.7 μm and 33 μm) have been produced by hot pressing. The fracture behavior of the composite ...
Welded penstock, produced of high-strength steel and application of fracture mechanics parameters to structural integrity assessment
(Springer, Dordrecht, 2008)
Application of high-strength steel for welded penstock increased the probability of crack-like defects and in welded joint. Structural integrity assessment procedure is presented and applied to welded penstock produced of ...
Evaluation of damage of steam pipeline steel using local approach to fracture
(American Society of Mechanical Engineers, Pressure Vessels and Piping Division (Publication) PVP, 2008)
In the paper, the level of damage of steam pipeline steel after about 100,000 hours at 540°C (1004 °F) under pressure of 42 bars (609 PSI) is analyzed. Material degradation is estimated using a combined experimental and ...
Numerička analiza loma zatezne epruvete sa prslinom u ZUT / Numerical analysis of tensile specimen fracture with crack in HAZ
(Kluwer Academic Publishers, 2006)
Numeričkim rešenjima se omogućava istraživanje složenijih problema, uključujući analizu pojedinačnih uticaja, posebno u slučajevima kada izostaju odgovarajući eksperimenti i matematička rešenja usled visoke cene, složenosti ...
Experimental determination of J-integral at elevated temperatures
(17th European Conference on Fracture 2008: Multilevel Approach to Fracture of Materials, Components, 2008)
In past two decades, the development of 9-12% Cr creep-resistant steel for critical components in coal-fired power stations that can withstand higher temperatures and pressures has been intensified in order to increase ...
Modelling of ductile crack growth in welded joints using micromechanical failure criterion
(17th European Conference on Fracture 2008: Multilevel Approach to Fracture of Materials, Components, 2008)
In this paper, ductile crack growth in strength mismatched welded joints is considered. High-strength low-alloyed (HSLA) steel in quenched and tempered condition is used as the base metal. Two different fillers are selected ...
Analysis of loading steel structure of bucket wheel excavator by stress condition measuring
(Institute of Mechanical Engineering, 2009)
Micromechanical analysis of constraint effect on fracture initiation in strength mismatched welded joints
(Trans Tech Publications Ltd, 2007)
In this paper the micromechanical approach to ductile fracture was applied in a study of constraint effect on crack growth initiation in mismatched welded joints. The single-edged notched bend specimens (precrack length a ...
Crack tip strain on ship and in situ measurement in shipyards
(IFAC Secretariat, 2007)
The paper presents the application extent of procedures for measurement deformations on ships. The actual deformation distribution was measured on the surface of the specimen by the optical grating method (OGM) parallel ...