Претраживање
Приказ резултата 1-10 од 15
Computation Method in Failure Analysis of Mechanically Fastened Joints at Layered Composites
(Assoc Mechanical Engineers Technicians Slovenia, Ljubljana, 2012)
This paper considers a computation method in failure analysis of layered composites containing pin-loaded holes. The investigation is focused on developing a reliable computation procedure to analyze initial failure load ...
Improving structure dynamic behaviour using a reanalysis procedures technique
(Univ Osijek, Tech Fac, Slavonski Brod, 2013)
The present paper deals with the problem of improving dynamic characteristics for a sub-structure of bucket wheel excavator. The procedure is concerned with the analysis of the distribution of potential and kinetic energy ...
Stress Analysis of Hyperbaric Chambers of Different Geometries
(Trans Tech Publications Ltd, Stafa-Zurich, 2014)
Hyperbaric Oxygen Therapy (HBOT) is a method used to administer pure oxygen at a pressure which is greater than atmospheric pressure in order to increase the concentration of 02 in the tissues, blood and cells, and correct ...
Numerical-experimental analysis of the foldable containers strength
(Univ Osijek, Tech Fac, Slavonski Brod, 2015)
This paper describes the numerical and the experimental methodology for analysis of plastic packaging strength characteristics that are representative of its strength in the real life. Numerical analysis was conducted by ...
Process of generating of quality solution of the oil gear pump which is leading to effectively high performance product
(Technics Technologies Education Management, 2012)
The paper is presented the basis of a procedural character of the generating of new products like hydraulic units with high quality and performance. The oil gear pump is present in various hydraulic systems that can be ...
Development of numerical-experimental model of connecting lugs and application on the lugs calculation of container terminals
(Elsevier Science Bv, Amsterdam, 2018)
The present paper describes numerical and experimental methodology and development of the model for stress and deformation state analysis of the connecting lug of container terminals. Numerical analysis was conducted by ...
The effect of cracks on stress state in crane wheel hard-surface under contact loading
(Univ Osijek, Tech Fac, Slavonski Brod, 2017)
Shown in this paper are the results of microstructure testing of crane wheels, along with the repair welding procedure performed by hard-surfacing. Repair welding involved the application of a welded layer to the crane ...
Evaluation of the Locking Compression Plates Stress-Strain Fields
(Univ Osijek, Tech Fac, Slavonski Brod, 2018)
Locking Compression Plates (LCP) have found application in the orthopaedic healing process in modern medicine. Their design is specifically modified depending on the bone and the loading the specific bone is subjected to. ...
Numerical-Experimental Determination of Stress and Deformation State in Connecting Lugs with the Effect of Contact Area Size
(Univ Osijek, Tech Fac, Slavonski Brod, 2019)
The present paper describes numerical and experimental methodology for the analysis of stress and deformation state in structural elements with geometrical discontinuities. The research is based on structural elements of ...
Tačka najvećeg napona na konturi kvadratnog otvora u ploči / Hot spot along corner curvature of rectangular plate opening
(Univerzitet u Beogradu - Mašinski fakultet, Beograd, 2019)
Koncentracija napona u uglu kvadratnog otvora u ploči je poznata činjenica. Najčešće se uzima da je najveća koncentracija napona u samom temenu ugla (na ugaonoj koordinati od 45 stepeni u slučaju kvadratnog otvora). ...