Претраживање
Приказ резултата 1-10 од 162
Weibull probability distribution for reactor steel 20MnMoNi55 cleavage fracture in transition temperature
(Elsevier, Amsterdam, 2020)
This paper presents the results and methods used for determining of fracture toughness of reactor steel, denoted as 20MnMoNi55, typically used for structures working at low temperatures, in transition temperature area. In ...
Influence of second-phase particles on fracture behavior of PLA and advanced PLA-X material
(Elsevier Science Bv, Amsterdam, 2021)
Most widespread materials in Additive Manufacturing are PLA (PolyLactic Acid) and ABS (Acrylonitrile Butadiene Styrene), which are dissimilar materials in terms of printing abilities and mechanical properties. PLA material ...
Composite material selection for aircraft structures based on experimental and numerical evaluation of mechanical properties
(Elsevier Science Bv, Amsterdam, 2021)
In this paper determination of mechanical properties of composite material using experimental and numerical approach is presented. The mechanical properties of a laminate obtained in the experiment are used for verification ...
Numerical simulation of fatigue crack growth in AA6156 T6 panels
(Elsevier B.V., 2021)
Fatigue crack growth in a panel with 4 stringers and 3-clips, made of AA6156 T6, was modelled numerically using xFEM. The central crack of the length a=17 mm was propagated in the total of 91 steps (in each step crack ...
Crack propagation in 3PB specimen made from welded joint
(Elsevier, Amsterdam, 2020)
Crack propagation in 3PB specimen has been investigated experimentally by using Digital Image Correlation (DIC) technique. For this purpose, specimens were taken from butt welded plates, made of P460NL1 micro-alloyed steel. ...
True Stress-strain Curves for HSLA Steel Weldment - Iteration Procedure Based on DIC and FEM
(Elsevier, Amsterdam, 2020)
True stress-strain curves of HSLA steel welded joint regions were estimated by using numerical simulation of strains measured by DIC and special iteration procedure to match the results. Strains were measured at certain ...
Rules of Risk Management - Case Study of Open Pit Mine
(Elsevier, Amsterdam, 2020)
The issue of human factor risk and rules and regulations in open pit mine is a main focus of this paper in order to develop predictive models of behavior of workers in relation to compliance with the procedures and rules. ...
Design Aspects of Hip Implant Made of Ti-6Al-4V Extra Low Interstitials Alloy
(Elsevier Science Bv, Amsterdam, 2020)
The main concerns in design of hip implants are fracture and fatigue related issues. In this paper, reverse engineering is used to redesign a hip implant produced by precision casting, using Ti6Al4V Extra Low Interstitials ...
Extended FEM analysis of fatigue crack growth in Ti-6Al-4V orthopaedic plates
(Elsevier, Amsterdam, 2020)
The extended finite element method (xFEM) was used to analyse fatigue crack growth in orthopaedic locking compression plates (LCP), made of Titanium alloy, Ti-6Al-4V, loaded in four-point bending. The optimal geometry was ...
FEM simulation of welded joint geometry influence on fatigue crack growth resistance
(Elsevier, Amsterdam, 2020)
Fatigue behaviour of welded joints is investigated, in terms of welded joint geometry and the fatigue crack position. It is based on previous work which involved numerical simulation of fatigue crack growth in a welded ...