Pretraživanje
Prikaz rezultata 1-10 od 29
Techno-economic optimization of plant for raw ethanol production based on experimental data
(Pergamon-Elsevier Science Ltd, Oxford, 2014)
This paper concerns techno-economic optimization of the production process of raw ethanol in a continuous distillation column as a part of the plant for production of rectified alcohol. Optimization was performed in order ...
Active boundary layer control in linear cascades using CFD and artificial neural networks
(Elsevier France-Editions Scientifiques Medicales Elsevier, Issy-Les-Moulineaux, 2014)
Flow field in linear cascades under high subsonic/transonic conditions has been investigated numerically. Active boundary layer control was employed in the form of sources (jets) distributed across the upper surface of the ...
Application of mathematical model for container transport flow of goods: From far east to Serbia
(Faculty of Mechanical Engineering and Naval Architecture, 2014)
This paper analyzes the supply chain network with primary focus on import of containers from Far East to Serbia through selected Mediterranean ports (Koper, Rijeka, Bar, Thessaloniki and Constanza). An optimization ...
Control algorithm applied on the diesel engine
(VDI Verein Deutscher Ingenieure, 2014)
The failure analysis of the star-separator of an aircraft cannon
(Pergamon-Elsevier Science Ltd, Oxford, 2014)
This paper analyzes the causes of fracture of the double pipe aerial cannon stellate starseparator, which occurred during the fighting plane mission. The linear finite element method (FEM) is used to determine the stresses ...
Radiative heat exchange inside the pulverized lignite fired furnace for the gray radiative properties with thermal equilibrium between phases
(Elsevier France-Editions Scientifiques Medicales Elsevier, Paris, 2014)
The objective of the research was to find if an agreement of the results of a numerical investigation with experimental data could be achieved considering the two-phase medium in thermal equilibrium. Influence of the gray ...
Effect of Exploitation Conditions and Flaw Geometry on the Load Carrying Capacity of Casing Pipes for Oil Drilling Rigs
(Trans Tech Publications Ltd, Durnten-Zurich, 2014)
The subject of this work is examination of API J55 steel casing pipes manufactured by high frequency (HF) contact welding. Since the pipes were withdrawn after about 70 000 hours of service in an oil drilling rig, the ...
Structural, mechanical and tribological characterization of Zn25Al alloys with Si and Sr addition
(Elsevier Sci Ltd, Oxford, 2014)
The ZA-27 alloy is a zinc-aluminium casting alloy that has been frequently used as the material for sleeves of plain bearings. It has good physical, mechanical and tribological properties. However, one of the major ...
Impact Toughness of Friction Stir Welded Al-Mg Alloy
(Carl Hanser Verlag, Munich, 2014)
Al-Mg 5083 alloy was friction stir welded by varying welding variables, i.e., rotational speed, traversal speed and tool tilt angle. Welded specimens have been tested by the instrumented Charpy test to evaluate total ...
Calculation of maximum tensile and shear forces in restorative materials using finite element method
(Trans Tech Publications Ltd, Durnten-Zurich, 2014)
The purpose of this paper was to determine tensile loading that leads to dental restoration failure, i.e. the critical values of stress. In order to analyze stress distribution within the restoration and tooth, mechanical ...