Pretraživanje
Prikaz rezultata 1-10 od 12
Thermohydraulic experimental design for the European Helium-Cooled-Pebble-Bed Test Blanket Module
(Elsevier Science Sa, Lausanne, 2008)
The peculiarities of the coolant flow in Helium-Cooled-Pebble-Bed Test Blanket Module (TBM) are (i) very intensive heating of the first wall from the plasma side and (ii) very complicated geometry of How domain consisting ...
Modelling of ductile crack growth in welded joints using micromechanical failure criterion
(17th European Conference on Fracture 2008: Multilevel Approach to Fracture of Materials, Components, 2008)
In this paper, ductile crack growth in strength mismatched welded joints is considered. High-strength low-alloyed (HSLA) steel in quenched and tempered condition is used as the base metal. Two different fillers are selected ...
Study of the simulated heat affected zone of creep resistant 9-12% advanced chromium steel
(Taylor & Francis Inc, Philadelphia, 2008)
Global warming leads to research-development attempts worldwide with a view to reduce CO2 emission. Therefore, in the energy supply sector, a special focus has been directed to further development of steels that can endure ...
Transition temperature and fracture mode of as-castand austempered ductile iron
(Wiley, Hoboken, 2008)
The ductile to brittle transition temperature is a very important criterion that is used for selection of materials in some applications, especially in low-temperature conditions. For that reason, in this paper transition ...
Experimental determination of J-integral at elevated temperatures
(17th European Conference on Fracture 2008: Multilevel Approach to Fracture of Materials, Components, 2008)
In past two decades, the development of 9-12% Cr creep-resistant steel for critical components in coal-fired power stations that can withstand higher temperatures and pressures has been intensified in order to increase ...
Modelling of ductile fracture initiation in strength mismatched welded joint
(Pergamon-Elsevier Science Ltd, Oxford, 2008)
In this paper, the effect of strength mismatch and width of the welded joints oil the stress-strain distribution in the crack tip region has been discussed. The single-edge notched bend (SENB) specimens (precrack length ...
Evaluation of damage of steam pipeline steel using local approach to fracture
(American Society of Mechanical Engineers, Pressure Vessels and Piping Division (Publication) PVP, 2008)
In the paper, the level of damage of steam pipeline steel after about 100,000 hours at 540°C (1004 °F) under pressure of 42 bars (609 PSI) is analyzed. Material degradation is estimated using a combined experimental and ...
Welded penstock, produced of high-strength steel and application of fracture mechanics parameters to structural integrity assessment
(Springer, Dordrecht, 2008)
Application of high-strength steel for welded penstock increased the probability of crack-like defects and in welded joint. Structural integrity assessment procedure is presented and applied to welded penstock produced of ...
A computer code for the prediction of mill gases and hot air distribution between burners' sections at the utility boiler
(Pergamon-Elsevier Science Ltd, Oxford, 2008)
One of the main tasks during the design or simulation and analyses of the utility steam boiler operation is the prediction of a distribution of mill gases and hot air flow rates between burners' sections. These are the ...
Ductile crack growth initiation in welded joints - Micromechanical approach
(Welding in the World, 2008)
The integrity of welded structures depends on the load-carrying capacities of their welded joints. Having in mind that welding process produces a large microstructural gradient through the weld, resulting in variation of ...